5LikesSC10 4x4 Thread
04-14-2012 | 03:54 PM
Tech Addict
iTrader: (-1)
Joined: Oct 2011
Posts: 664
Awesome!!! Pm me your address and il mail u three orion packs for free lol
04-14-2012 | 04:22 PM
Hartson and Numedahl are 1 and 2 at Mike's Hobby Shop in 4wd SCT.
Marcus is #10.
Hartson is TQ in 3 classes, dude's on fire. Kody's is TQ in 2wd SCT.
I think the AE boys are looking to make a statement. Wish I could watch the races live.
Marcus is #10.
Hartson is TQ in 3 classes, dude's on fire. Kody's is TQ in 2wd SCT.
I think the AE boys are looking to make a statement. Wish I could watch the races live.
04-14-2012 | 04:31 PM
Tech Apprentice
Joined: Sep 2010
Posts: 76
Micheal Twilling at #8 runs an SC10 too...
04-14-2012 | 06:59 PM
One of the AE drivers helped him set up his truck and apparently it's dialed now. I'll be taking some notes when he gets back. I'm stoked he's doing so good down there, and I won all my classes tonight since he's gone. 
A few guys at my track including Twills were having problems with the FT. One guy ripped all the electronics out of it after the first heat and put it them back in his old one, then threatened to run it over with his real truck lol.
A few guys at my track including Twills were having problems with the FT. One guy ripped all the electronics out of it after the first heat and put it them back in his old one, then threatened to run it over with his real truck lol.
04-14-2012 | 08:47 PM
Tech Elite
Joined: Oct 2011
Posts: 2,069
A few weeks after owning the truck I noticed the stock front right A arm was warped. It was warped bad enough to cause me to bend a CVD. Chris at AE took care of those items for me under warranty.
I was concerned that I would have more issues with the stock arms as they were extremely flexible so I replaced them with RPM arms a month ago. I was going through the truck tonight and replacing the hinge pins with the FT Ti hinge pins. I just noticed that the left rear RPM arm is warped now too. Hinge pin is very hard to push in so it is obvious that the arm is due for the trash.
I store the truck on a stand with wheels off.
What is up with these arms that cause them to warp so easy?
I was concerned that I would have more issues with the stock arms as they were extremely flexible so I replaced them with RPM arms a month ago. I was going through the truck tonight and replacing the hinge pins with the FT Ti hinge pins. I just noticed that the left rear RPM arm is warped now too. Hinge pin is very hard to push in so it is obvious that the arm is due for the trash.
I store the truck on a stand with wheels off.
What is up with these arms that cause them to warp so easy?