R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 17
1
2
3
11
Last »
Search: Posts Made By: B16A2
Showing results 1 to 25 of 421
Search took 0.02 seconds.
Forum: Australian Events
02-05-2019, 02:27 PM
Replies: 19
Views: 4,900
Posted By B16A2

What will be the control tyre for this event ?

What will be the control tyre for this event ?
Forum: Radio and Electronics
01-16-2019, 12:12 PM
Replies: 7
Views: 641
Posted By B16A2

No range advantage with higher voltage, the...

No range advantage with higher voltage, the receiver circuitry gets regulated down to about 3.3v from the BEC input. Its pretty much only the BEC rail that uses the higher voltages to power servos...
Forum: Radio and Electronics
10-28-2018, 03:13 PM
Replies: 3
Views: 2,895
Posted By B16A2

Yes most modern brand ESC's can be repaired after...

Yes most modern brand ESC's can be repaired after they have been connected in reverse

You will however require IRDA or SMD rework station, oscilloscope, DVM along with a quality soldering iron...
Forum: Radio and Electronics
09-18-2018, 04:54 PM
Replies: 5
Views: 1,282
Posted By B16A2

yes if your base cover is the plastic cover, you...

yes if your base cover is the plastic cover, you will need the micro star driver
Forum: Radio and Electronics
09-16-2018, 03:26 PM
Replies: 5
Views: 1,282
Posted By B16A2

Simply remove the screws from the underside of...

Simply remove the screws from the underside of the ECS's bottom housing, use your fingernail to pry the two housings apart, take note of the sensor wire connector seal orientation for reassembly.
...
Forum: Radio and Electronics
09-11-2018, 08:36 PM
Replies: 4
Views: 696
Posted By B16A2

Its a LRP ESC, I used to have the NOSRAM...

Its a LRP ESC, I used to have the NOSRAM equivalent "Matrix Evo ISTC", from memory brushed and brushless mode detection was automatic from the way the ESC was wired to the motor.

This ECS needs...
Forum: Radio and Electronics
05-16-2018, 02:22 PM
Replies: 5
Views: 1,514
Posted By B16A2

I used to run a 3 cell LiPo in my 3PK as the LiFe...

I used to run a 3 cell LiPo in my 3PK as the LiFe voltage was to low.

Regarding your power switch issue check both power switch positions, the primary large switch will switch the radio on with...
Forum: Radio and Electronics
04-26-2018, 04:56 PM
Replies: 4
Views: 2,316
Posted By B16A2

Typical ESC's are designed to pump out as much...

Typical ESC's are designed to pump out as much current as possible from the battery to the motor limited by the PCB design and the MOSFET rating, never seen an RC ESC with current limiting for drive....
Forum: Radio and Electronics
04-16-2018, 05:07 PM
Replies: 5
Views: 1,345
Posted By B16A2

That is possible, another test that will help you...

That is possible, another test that will help you understand what is happening is to use a scope on the PWM input to the RF section. Monitor both the voltage of the pot as in your video and the PWM...
Forum: Radio and Electronics
04-16-2018, 03:02 PM
Replies: 5
Views: 1,345
Posted By B16A2

You video shows the steering potentiometer is...

You video shows the steering potentiometer is working as expected however I did see a glitch on almost full left, (a scope would better indicate this). You can clean the pot with IPA to help with the...
Forum: Australian Events
03-22-2018, 02:34 PM
Replies: 38
Views: 6,595
Posted By B16A2

Is tyre cleaner controlled as well ?

Is tyre cleaner controlled as well ?
Forum: Radio and Electronics
03-22-2018, 02:20 PM
Replies: 4
Views: 621
Posted By B16A2

power wires to the radio are probably soldered...

power wires to the radio are probably soldered back to front on the battery compartment
Forum: Radio and Electronics
03-18-2018, 09:06 PM
Replies: 4
Views: 580
Posted By B16A2

Usually a pin holding the gears in place goes...

Usually a pin holding the gears in place goes sloppy due to wear in the housing allowing for the additional movement.
Forum: Radio and Electronics
01-22-2018, 01:39 PM
Replies: 7
Views: 1,622
Posted By B16A2

You should check the current load of the servo,...

You should check the current load of the servo, while the servo is in operation, also do you have any fans connected to the receiver
Forum: Radio and Electronics
10-29-2017, 01:14 PM
Replies: 212
Views: 99,711
Posted By B16A2

yes, the larger two wire AMBRc DP transponder...

yes, the larger two wire AMBRc DP transponder will cease working, the smaller MyLaps two wire transponder will continue to work.
Forum: Radio and Electronics
10-08-2017, 07:23 PM
Replies: 8
Views: 3,566
Posted By B16A2

Your steering pot in the radio is dirty,...

Your steering pot in the radio is dirty, dismantle the wheel and when you get to the pot clean it with Isopropyl alcohol. One spray into it and turn it many times with a small screwdriver gently.
...
Forum: Australia For Sale/Trade
09-17-2017, 07:12 PM
Replies: 2
Views: 523
Posted By B16A2

PM sent

PM sent
Forum: Radio and Electronics
08-24-2017, 10:01 PM
Replies: 3
Views: 562
Posted By B16A2

Use a multi meter to find the ground of those 3...

Use a multi meter to find the ground of those 3 pins under the regulator with the white sticker (9100096A) using the continuity test.

You can find ground from the top metal portion of the...
Forum: Australian Events
08-24-2017, 09:47 PM
Replies: 88
Views: 17,462
Posted By B16A2

Please allow for tables and chairs for all the SA...

Please allow for tables and chairs for all the SA entries, and that guy from ACT who is running mini (he can pit with us :))

Cover would be very nice
Forum: Australia For Sale/Trade
08-08-2017, 12:37 AM
Replies: 2
Views: 1,319
Posted By B16A2

Price drop $470 1x aluminium chassis and...

Price drop $470

1x aluminium chassis and Fleta Pro ESC no longer available and removed from sale.
Forum: Australia For Sale/Trade
08-03-2017, 02:13 PM
Replies: 2
Views: 1,319
Posted By B16A2

Bump with price drop to $550 Ill throw in a...

Bump with price drop to $550

Ill throw in a Muchmore Fleta Pro ESC as well. (no fan, wires or capacitor)
Forum: Australia For Sale/Trade
07-31-2017, 02:40 AM
Replies: 2
Views: 1,319
Posted By B16A2

Yokomo BD8 w/Fleta Pro ESC plus lots of extras

Yokomo BD8 TC with upgraded and spare parts. This car has only done 2 major events (TITC 2017 and SA State Titles 2017) and a handful of club meets.

• Black Hiro Seiko/ titanium screws top
•...
Forum: Radio and Electronics
07-30-2017, 08:05 PM
Replies: 2
Views: 554
Posted By B16A2

If you got away with just the diode failure on...

If you got away with just the diode failure on the cap board you dodged a bullet, usually the MOSFETS in the ESC fry regardless how long it was connected or how charged the battery was.

There...
Forum: Australia For Sale/Trade
07-19-2017, 08:15 PM
Replies: 2
Views: 489
Posted By B16A2

Sold

Sold
Forum: Australia For Sale/Trade
07-19-2017, 02:16 PM
Replies: 1
Views: 693
Posted By B16A2

Bump and price drop also found a spare front...

Bump and price drop

also found a spare front spool diff to add to the parts count
Showing results 1 to 25 of 421
 
Page 1 of 17
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.