R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: nikdfish
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: 3D Printing Forum
10-15-2019, 01:27 PM
Replies: 403
Views: 116,859
Posted By nikdfish

Printed a 95A TPU "flywheel" for a 3mm shaft with...

Printed a 95A TPU "flywheel" for a 3mm shaft with a slot for some reflective tape so a laser tach can check RPM.

While the TPU spool was still loaded, I also printed a two motor stand (540 motor)...
Forum: 3D Printing Forum
10-14-2019, 11:05 AM
Replies: 23
Views: 19,104
Posted By nikdfish

I have used semi-flex TPU (95A) to print cleats...

I have used semi-flex TPU (95A) to print cleats for tracked vehicles. They handle running on pavement pretty well. 95A is not gooey soft like ninja-flex, it feels more like bicycle or car tire...
Forum: 3D Printing Forum
10-14-2019, 10:58 AM
Replies: 58
Views: 36,084
Posted By nikdfish

I have an Ender 3 that I picked up as an early...

I have an Ender 3 that I picked up as an early Christmas gift to myself last year. It has had a few mods since then. One of the first was to burn a bootloader onto the stock controller so I could run...
Forum: 3D Printing Forum
10-14-2019, 10:39 AM
Replies: 403
Views: 116,859
Posted By nikdfish

I've been printing silica desicant boxes from...

I've been printing silica desicant boxes from semi-flex TPU. TPU isn't affected by 65° C temps in the dehydrator when "recharging" the silica, so it is a good choice in that respect. It is a bit...
Forum: 3D Printing Forum
10-14-2019, 10:08 AM
Replies: 23
Views: 13,243
Posted By nikdfish

I did the initial design using an involute gear...

I did the initial design using an involute gear library in OpenSCAD, then fleshed out the connection profiles in Tinkercad. It did take a couple of trial & error prints to get the gear mesh right...
Forum: 3D Printing Forum
10-14-2019, 10:00 AM
Replies: 23
Views: 13,243
Posted By nikdfish

I did some 4:1 helical bevel gears for an FPV...

I did some 4:1 helical bevel gears for an FPV Rover 2.0 build ( thing# 2952852 on thingiverse - can't do link in first post) as a re-mix of the original straight bevel 2:1 gear set, printed from both...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.