R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: urnotevenwrg2
Showing results 1 to 25 of 500
Search took 0.04 seconds.
09-06-2018, 09:35 PM
Replies: 738
Views: 246,687
Posted By urnotevenwrg2

The 1.5mm hex wrench is easier to break than a...

The 1.5mm hex wrench is easier to break than a 2mm wrench, especially if you are forcing threads into the material for the first time. I would tap the holes, but leave a little bit untapped to act as...
09-06-2018, 06:30 PM
Replies: 28,831
Views: 5,746,969
Posted By urnotevenwrg2

Go look at the times from when you practiced on...

Go look at the times from when you practiced on September 1st. After you left there was a guy turning 13.8's with a stock buggy. The problem with a rear motor is how it doesn't like to change...
08-30-2018, 03:09 PM
Replies: 4
Views: 1,940
Posted By urnotevenwrg2

The timing in the esc is ramped in by degree of...

The timing in the esc is ramped in by degree of timing over rpm, so the adjustments reflect that. Basically you can adjust how much timing the esc adds, and how quickly it add the timing. The timing...
08-30-2018, 01:08 PM
Replies: 13
Views: 1,388
Posted By urnotevenwrg2

Bill, I just went and weighed a 2wd and 4wd front...

Bill, I just went and weighed a 2wd and 4wd front wheel, and the 2wd wheel was less than a gram lighter. You saved weight because of the tire and insert. Stop saying you saved weight because of the...
08-27-2018, 02:28 PM
Replies: 613
Views: 180,852
Posted By urnotevenwrg2

Stickied right at the top of the page. LOOK...

Stickied right at the top of the page.

LOOK FOR A THREAD ON YOUR VEHICLE BEFORE POSTING NEW THREADS....
08-26-2018, 11:41 PM
Replies: 7
Views: 643
Posted By urnotevenwrg2

It could be a bearing has gone bad somewhere....

It could be a bearing has gone bad somewhere. Usually that will mean the motor will run hot.

It is very likely the battery. Try a different battery to see if the problem goes away.
08-26-2018, 11:34 PM
Replies: 732
Views: 247,788
Posted By urnotevenwrg2

The SC6.1 has a lay back transmission stock, not...

The SC6.1 has a lay back transmission stock, not a lay down. A lay down moves the motor weight forward from where it is with a lay back. The gear diff and ball diff both fit in any of the...
08-26-2018, 07:49 PM
Replies: 732
Views: 247,788
Posted By urnotevenwrg2

Look at the B6.1 and B6.1D setup differences and...

Look at the B6.1 and B6.1D setup differences and copy the same ideas. A lay down gear box, gear diff, and some thick sway bars are probably going to be stuff you will have to buy to make an SC6.1C.
08-26-2018, 12:00 AM
Replies: 48
Views: 8,756
Posted By urnotevenwrg2

What kind of internal resistance numbers are you...

What kind of internal resistance numbers are you seeing on the cells?
08-24-2018, 07:41 PM
Replies: 8
Views: 1,794
Posted By urnotevenwrg2

Yes, that is normal. That happens because of the...

Yes, that is normal. That happens because of the discharged capacitors on the esc.
08-23-2018, 06:25 PM
Replies: 4,350
Views: 1,207,621
Posted By urnotevenwrg2

What is the fastest lap you have seen someone do...

What is the fastest lap you have seen someone do at your track?
08-23-2018, 05:38 AM
Replies: 7
Views: 918
Posted By urnotevenwrg2

That the two servos process the signal from the...

That the two servos process the signal from the receiver differently.

If you've got full steering travel what does it matter?
08-22-2018, 06:42 AM
Replies: 3,819
Views: 1,074,298
Posted By urnotevenwrg2

Actually,...

Actually, (https://m.techxplore.com/news/2018-03-temperature-lithium-dendrites.html) occasional high current cycling is good for the batteries. Honestly, batteries last about a year with the high...
08-22-2018, 12:46 AM
Replies: 3,819
Views: 1,074,298
Posted By urnotevenwrg2

Racing is so much more difficult than bashing...

Racing is so much more difficult than bashing that you are in for an eye opening experience. Like prepare to struggle and feel like you are in the way for the next 3-5 years at least. After that...
08-21-2018, 08:44 PM
Replies: 28,831
Views: 5,746,969
Posted By urnotevenwrg2

Cool, I want to get up to Fast Lane this winter....

Cool, I want to get up to Fast Lane this winter. How is the grip this time of year vs. winter?

I ran the b5m spindles and c hubs on my Tamiya. I know the foibles of that front end.
08-21-2018, 03:05 PM
Replies: 28,831
Views: 5,746,969
Posted By urnotevenwrg2

So did all of the B6 parts make it work any...

So did all of the B6 parts make it work any better?

This shows that driving ability is still what matters most. I've recently got my old rear motor stadium truck going again, and have not had any...
08-20-2018, 03:31 PM
Replies: 13
Views: 6,006
Posted By urnotevenwrg2

Negative goes towards the edge, signal towards...

Negative goes towards the edge, signal towards the center.



So the positive (which is the center wire on the connector) is the pin toward the edge? Also, that grey wire is the antenna, not a...
08-20-2018, 12:20 PM
Replies: 6
Views: 544
Posted By urnotevenwrg2

1. It is called a transponder. The lap counter is...

1. It is called a transponder. The lap counter is the computer the race director uses.

2. The Tekin RS has a 6v bec. So your servo might be safe for 7.4v, but it is not seeing 7.4v hooked up to a...
08-19-2018, 10:43 AM
Replies: 4
Views: 1,019
Posted By urnotevenwrg2

On the radio make sure the throttle trim and sub...

On the radio make sure the throttle trim and sub trim are at zero. Make sure the throttle and brake end points are at 100%. Make sure the throttle channel is not reversed.
08-16-2018, 10:50 AM
Replies: 3,084
Views: 793,890
Posted By urnotevenwrg2

How many laps down from the leader do you finish?...

How many laps down from the leader do you finish? If you can't drive a box stock car hard enough to finish on the same lap as the leader, dumping a bunch of money into your car is not going to make...
08-16-2018, 09:59 AM
Replies: 2
Views: 507
Posted By urnotevenwrg2

Just trim a little bit off the ball cups so you...

Just trim a little bit off the ball cups so you can make the link the correct length. Use a new razor blade, and make sure to keep it square when making your cut.

The floating servo mount is to...
08-15-2018, 08:34 PM
Replies: 17
Views: 1,656
Posted By urnotevenwrg2

How long have you been using Simple Green for rc...

How long have you been using Simple Green for rc tires? Back in 2013 (https://en.m.wikipedia.org/wiki/Simple_Green) they took 2-butoxyethanol out of Simple Green. 2-butoxyethanol is a solvent. They...
08-15-2018, 08:17 PM
Replies: 4,768
Views: 1,158,473
Posted By urnotevenwrg2

First off, a "wheeler" is slang for a 4 wheel...

First off, a "wheeler" is slang for a 4 wheel drive buggy, so you are not running a 2wd wheeler.

Second, there is a gearing chart in the instruction manual. It will give you a safe starting...
08-14-2018, 12:49 PM
Replies: 17
Views: 1,656
Posted By urnotevenwrg2

They had to change the chemical makeup of simple...

They had to change the chemical makeup of simple green back in 2013 for them to be able to call it "environmentally friendly". Even before 2013 they'd removed oil of wintergreen as an active...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.