Ok I am getting this reset to factory settings still on my RX8 gen2. I have had it consistantly maybe like 4 or 5 times since first post on 12-15-13. I have been saving and reading current settings to verify save afterwards for proper settings. I am seeing this as software issue and currently playing with order I close things out or disconnect wire afterwards of a hotwire session. I have no other issues with anything else and love my Tekin stuff. Great product for me. Any sugestions?

I know it was asked before and mentioned in the post you quoted but do you "save" settings after making changes in hotwire? Or do you "apply" settings?

Yes, you need to update your Rx8's software. What are you on now?

Sorry I did not make this clear. I apply settings then hit ok as prompted then read current to verify the take. Hope this helps. Unless I am wrong saving is just to a computer file.

Thanks

When you make a settings change via the Hotwire you must "Apply settings" to save them in the esc. "Save Setup" is only going to save the currently "applied" settings in the esc to a file for later use.

well i started to reply that i had version 244. but i said ill double check. and nope 238. i updated ike early december i thought. close to the time my problem started i suppose looking back now. who knows. likely my fault for not having made sure of updated software assuming this will be the fix.

thanks guys:sweat:

Randy-

Do you know what the approximate time it takes a service item to be repaired (or probably replaced in my case) is right now. You received my rx8 last week and I have a race this weekend that I will be needing it for and I would like to know if I will have it back before Thursday, because if not, I will have to find someone with a spare.

Thanks

In general it's 7 to 10 business days once we receive it.

Last time you sent me another one the same day you received the broken one. Must have gotten lucky.

looking for a setup sheet. looked on tekin's website but I cam up empty.
thanks.

what is the dimensions of screws that are holding the back plate of the gen2 T8 motor?

For what car? with what motor?

The rear endbell plate? or the sensor board? Just wanting to be clear.

sorry, i forgot to write that its a gen2 T8 2050kv and im using it on my eb48.2.
and i mean the rear alum plate ( I think is what you call the end bell).
the screw that got lost is the top one. i think its the one that suppose the hold the sensor wire clip.

Scte 2.0 rx8 gen2 43gen2 4300 hd
8ight 3.0 rx8 t8 1900 or 1950...can't remember

Thanks!