Programming different modes in Reventon Pro
 

With the Reventon Pro, is there a way to easily change modes from Blinky mode, to Mod 1, or Mod 2 with changes made from the program card? Or do you have to reprogram the esc through the program card using the PC program. Sorry very new to Speed Passion escs. :tire:

Only way is connecting program card to PC, BUT I think the wifi or bluetooth adapters will let you. I am not 100% sure on that though.

You can with wireless modules

Will a rev pro do it

can the reventon pro compete with the likes of hobbywing xerun, tekin rs pro etccc...???

You will always have to hook up the Programming Card and your PC to change firmware. The Bluetooth/WIFI modules eliminate the need for a card + PC.


Of course it can. There are tons of guys running it at every level from the RTR Durangos all the way up to the Factory team guys running modified.

Yes... I switched from a Sxx comp.... Better IMO... Ton smoother than a Tekin and a breeze to adjust parameters

In my new Reventon R there was a two part warranty card that you are suppose to mail back half of it. There is no address, where do you send it and has anybody actually done this?

Register online

Rec pro & mmm 10.5
 

Order on Wednesday this wk and just got it in mail today. Wow great job SP. Now time to install in my dex210 anyone using the high current connectors how do u install?? Can't wait it have her running

Pics of rev pro ??
 

Installing rev pro & mmm 10.5 in dex210 rm3 config anyone have pics of placement my motor wire are short. Thanks

You could just mount it like the RTR 210. It comes with a Speed Passion ESC (Not Reventon). If the wires are too short, just solder new ones up.

Here's the RTR..

http://www.team-durango.com/race-car...lery/01/10.jpg

BLUETOOTH help needed.

bought and installed one. It worked for a couple changes then stopped when i mounted it in the car. When it is plugged in i get no drive to the motor. However I will retain steering.

When i connect to the phone it will connect but i am unable to make changes then it will say it can not connect.

I have tried it on 3 different reventon pros and it is the same on all of them. I have gone threw the setup mode with it several times and it will not work properly.

Is there something that I am doing wrong? anything that i may be missing in setup or trouble shooting?

This is exactly how mine in my desc210 is.

any word on when the 550 blaze motor is coming out.