Stock 0 update coming soon???

I have a KO radio and it works great. Throttle in reverse on the radio then rebind. When you do that the radio setting forward and brake remain the same and adjust accordingly. I had a exur5 and had to do it with my Tekin ESC

so reventon pro,s came today.from what i have read.
make sure the drrs isnot set low

low cell=off
neutral dont set low.
and there was something on getting the reverse to work.

can someone tell me what the latest firmware these should have?

could use some help with a few questions.

esc=reventon pro-modify1 v16 software

need to run blinky mode.

do i need to download a different firmware to esc for blinky.
i did put the timing to zero,but no esc lights flashing.

i have also read i must update the lcd program card

You need to down load the firmware to your PC
http://www.speedpassion.net/reventon/home.asp?t=5

Update you LCD program box and set the Stock 0 profile to your esc.

A very minor UPDATE per ROAR requested.....just the software's name has to match what ROAR approved...which is STOCK0 V20. But when it is out, make sure use it....

I am wondering...what is your car..? And what causes the reverse rotation...?

Understand this...if you are running SENSORED...only the SOFTWARE (if equipped) will allow you to reverse the rotation. For GT2.1, there are no software to do so.....sorry.

The only way to reverse the rotation of the motor is...use sensorless. unplug the sensor wire, you CANNOT use it. Then rotate the A and C wire (I think that is the way....FYI, I never tried it...I only heard about it). And the motor rotation will be reverse. And you will never be able to use timing and boost from the ESC.

Just try to find out WHY you need to reverse the rotation of the motor..?

thanx for the help.

can more than one profile(stock-0,mod-1) firmware be installed on one program box.

or must i have multiple boxes?

Youll have to plug in to the PC each time. But that would be an awesome featire to eventually have. But i think thats the point with the new blue tooth stuff?

Are they available here yet?

see,
are you going to fawl brawl tommorow, if you are i will show it to you. works awsome. clint knows who i am. i works awsome no more pc all loaded in phone.

I will be there I know who you are I will come check it out.

ok I got a second hand gt 2.0 pro. I havent been able to get it to work since I have owned it. Im using a spektrum dx3r in case I have something set on the radio wrong. But I cant get the speedo to power my rx without the use of a external bec. But even with the bec connected I cant get the speedo to set to my radio. Im programming it exactly the way the directions say to do so. Have the radio on, holding down the set button and then turning on the switch. I have a red light blinking when I do this. But then I click the set button to set neutral and there is suppose to be one green light flash after I do this and I have no lights after I click the set button. Im lost here

What servo are you using? Many new servos require a capacitor connected to the receiver. This is why Spektrum makes their own capacitor that plugs into the receiver.

Here is a video that walks you through the steps. If this is still not working please let us know. You can PM me or contact Speed Passion USA directly.

==

Reventon Firmware Update

Many of our racers and customers asked and Speed Passion came through. In the newest update for your Reventon you can set "custom" drag brake profiles. You still have the option to select the predetermined values or set custom drag brake in 1% increments!

I dont have a servo connected to it. Also there is no link on your post that shows a video