Originally Posted by bring it on (Post 9315524)

Ok, I have 2. :nod: LOL

Originally Posted by bring it on (Post 9315482)

Here are the results of my Nitro Buggy A main. There was only 3 e-buggy's today so we had to run with the nitro's. You can see what position i was in when we pulled off at the 14 minute mark. The number in front of the lap times tells you what position your in. I got 1st place today. The viper 2050kv motor with the new test
14.5mm rotor ran GREAT.
http://i726.photobucket.com/albums/w...-11bugmain.jpg

Originally Posted by tibbs (Post 9315531)

My esc did the same thing it just shut of and won't turn back on and if it did turn on when u give it gas it just shuts down . I was using a viper 17.5 and it never got warm so I sent it in last week so we will see what they say?????? I had only used it maybe 5 times before this happened...

Originally Posted by SC_RAGE (Post 9315919)

Would you mind sending us some test results. We have handed out many motors and rotors and never seem to get test results. Funny how that works. It would be greatly appreciated.:nod:

Originally Posted by bring it on (Post 9315959)

wow, really? Weylin has tons of testing results and i just talked to him today for about 30 minutes on the phone. I can send you the results to if you like? What's your email? Do you not work with Weylin?

Originally Posted by SC_RAGE (Post 9299122)

Had a great day of testing and found some helpful settings for those of you running our VTX10R ESC and planning on running our 550 motors.

VST4.5XL-14tooth pinion. VTX10R-Profile#2, Brake strength 80%, Brake PWM freq 8000HZ, Brake curve linear, Neutral drag brake 10%, Throttle PWM freq 9600Hz, Throttle punch 15%-20%, Throttle curve linear, Deadband middle, no timing- default, no motor protection, esc protection 240 degrees. (esc temp 120-140)-(motor temp 150-170)

Originally Posted by UK.hardcore (Post 9322214)

How high is VTX10 from bottom to top of powers caps?

thanks

Originally Posted by mcheroke (Post 9316179)

Raced at West Coast RC Raceway yesterday and dialed this setup in my sc10 4x4 w 10r and tekin 4.5 and these settings were MONEY! Dialed in a little more motor punch and some more drag break but it made the truck drive much smoother and was able to get my temps in range w/ the 14 tooth pinion. Thanks Rage for the info

Originally Posted by Brian Alderman (Post 9323200)

I just ordered one of the 13.5s for 2wd buggy, can't wait to try it. Now I kind of wish I would have waited to see how the 1/8th system works but I went with the Tekin.

Originally Posted by SC_RAGE (Post 9322684)

16mm exactly