And the 119 that you are talking about is for the speedo not the 2.1 box

Well id like it on both. Is it something to do with the fact that i cant open a rar file?

After loading the disc it says that there are two files on it. One is an application and the other a rar file which i just cant open.

look for a trusted program online to open it, load the program first then extract the rar file.

Ok mate. Thanks. A job for tomorrow now as im out of steam.

any news software update or new esc update ?

Check the sensor cable... if the ESC is flashing green after the run, it's dropped into sensorless mode, in which case no boost turbo will be applied.

HiH
Ed

none as you all wish

120A for use with 550 motor
 

i started using one of my 120A HW ESC on my SC10 4x4 with a 550 Tekin 5.5 motor it works great very smooth and linear. My only concern is when i calibrate the ESC to my radio i dont get the LED blinks i do get the beeps from the motor is this normal? Has anyone else used this on a 550 can motor?

HW never officially released a software package with both those versions in it, so they never bothered about back and forward compatibility.

In USB link package V1.63_110310, downgrade your ESC to V2.0_100518 (Version 2 firmware)
Then downgrade your 2 in 1 box to 101224
Then close USB link package V1.63_110310, and start USB link package V1.63_101224, (ignore the message about upgrading)
Then upgrade your ESC to V3.0_101224
You should try to instal those HW packages next to eachother on your PC (create a seperate folder before you unpack the rar file). This give you the opportunity to go any way you want.

Connect your X12, go easy on the boost/turbo and be very surprised!....
101224 has a total of 46 steps boost/turbo of which 38 boost and 30 turbo, but I run 18-20 boost and 6-9 turbo, and nothing more!
Turbo start RPM: 6000
Turbo slope: 450 - 600 rpm/step
Turbo delay: 0.4s

Something like that.
X12 with 4 dots insert.

Thanks a mil, I will give it a go again later on and see how i fare, just one question, have you tried 0 timing on LRP (0 dots) instead of 4 dots, I run 0 timing with my RS pro to good result but then I have 40 boost and 20 turbo which probably compensate.

The rest of your setup is what I already have on, thanks again.
Olly

Hi, I made an edit in my previous post, because there was a mistake, which is still in your quote, never mind, but maybe somebody gets confused...

Ehh, no I never tried 0 timing, because the 4 dots is -10 (endbell) timing, the lowest timing possible on a X12, which will help in gaining punch, let the ESC add timing for speed.

Ok thanks, I edited the quote too.

You see what I mean now about all these differents versions, even you, you mix them :lol:

Olly, This might also help to get the 224 FW. Instruction by Shawn. http://www.rctech.net/forum/electric...tware-371.html