Does anyone have more info on this question? I am going to be building my MBX6 very soon and with my two high voltage servos I want to be able to use my lipo unregulated. Operating Manual states on page 5 that the input voltage is 4.8v-6.0v. I want to be sure it can handle the 7.4v from the lipo and really more like 8.4v which is what they are when fresh charged. If not what are my options other then a regulator? what are the input voltage of the 451R??

Sean

Hello matey,

I have been running the 451 receiver unregulated since december and have no problems at all with it. I believe however that sanwa have now released new receivers capable of running 7.4v direct (without risking the warrenty.)

Liam G.

if i using 451 receiver with unregulated 2s lipo battery,but didn't got high voltage servo (using Sanwa WX & DS1015) got any problems??

M11X Lipo battery & charger harness questions?
 

I have a M11X, using 'standard" battery pack in transmitter, and would like to get Lipo for transmitter.

Vehicles I race have tekin motors, esc, and Associated DS1015 servos.
Also use Airtronics receivers.

Is there anything special I would need to change radio battery to Lipo? I know I need it to be at least 1800Mah, and 2S, but wondered if there was anything else I needed to know or worry about?

Does anyone know where to get them for a reasonable price?
Thanks in advance.

I got my LIPO pack from RCMUSHROOM:

http://www.rc-mushroom.com/product_i...ducts_id=20358

http://www.rc-mushroom.com/images/IP-2300S2S_L.jpg

I take it out from the transmitter when charging, I balance it as well before using. After use, I will charge it on STORE mode before putting it away.

Lipo for M11X
 

Thanks for the information. Ordered it today.

Can anyone hook me up with a good starting point for the anti-lock break and traction control settings. I kow it is all preferences but I am new the M11x and am not for sure where to start. I run both nitro and electric
MBX6T'S so any help would be great. I run the tekno kit with brake servo with my MBX6T(E) but I am not for sure if the alb feature will work with it. I mostly run on medium to large tracks, alittle loose, with alot of jumps. Thanks.

Hi Guys! Just bought my m11x few days back. Could anybody tell me, if i get a 451r receiver can i use futaba 9451 servo? or i must the new sanwa servo?

this servo are digital or not,if digital,i will work|!!

Hmm.. Yes, it is a digital high speed servo.
Thanks for your help bro!:D:D:D:D:D

Hmmmm....having a problem here. When I go full throttle in my truggy, when i let off it goes to half brake. It did this with my last hitec servo, it was analog so i switched to a digital JR. It hasn't done it in quite a while, but today it started it again! Quite frustrated, and I don't know what the heck is wrong with it. Could it be a setting on the radio that I'm hitting and just don't know it?

have you do the vr adj after the epa setting???

Not quite sure what you mean....

check the f3 page on radio,vr-something then adjusting it!!

Roger will do! Thanks!