same process

but do i have to set up a new model or just bind it??

either or I would set up as new but you do not have to you can do that later.

first change model then push the button on rx(receiver) before it got power,then go to bind menu and start the binding!

Hello!
I have one question about Sanwa M11X. Does the Sanwa RX451 can handle Lipo receiver pack w/o voltage regulator?

yes my friend have try no prob to date

hi there, im still having problems add an extra reciver. i managed to make a new model and bind a new reciver to that model. but when ever i switch back to the first model the reciver that i have bind to that doesnt work. anyone know what i should do.

............

have you try the nimh rack or other battery??

yes...still same...i think want to send back factory..but i dunno how..any suggestion???:confused::confused::confused:

folks I was having similar problems with the included nimh battery packs, you have to either leave it on charge constantly while at your track or do what I did and bought a nice lipo pack... make sure it is over at least 1800mah but 7.4v 2s only!!

since then my radio has been working flawlessly

I"m pretty sure a few guys plugged their lipos in backwards and it fried an internal fuse. Check back a ways on this thread and you'll see what i'm talking about. Maybe this is your problem

as I know Xpro rc radio not working on the LCD only, the radio is able to turn on and remote/play without any issue. I think most probability is the LCD fault.

I dont think so! Because it is simply not Possible to plug any Lipo Connector the wrong way into the Sanwa M11X, if the Lipo wires arent changed Manually and switched black and red at the Connector.
If its all Factory- its simply not Possible!

........