Post service in Russia... Please bribe them or something....

Hey TG... GREAT JOB... Well done to you and your team...

I was wanderring a few things...

What sort of RPM can we expect from this monster?
Also Torque,
HP,
Are you planning on getting a few of the mags to test it, I know we can get RCNitro here in SA, I am subscribed and they do Dyno's you may get greater demand like that, I am starting to create a small demand here with the locals, will see, will let mod... I mean Palmaris Europe know how things go.

Unfortunately, we dont have these figures at this present time. I like the RCNitro mag myself. I believe TG is sorting out a review with them.

I got your last email and will send you a reply now shortly. Got a few things to take care off.

modellor

There's a picture of the P12 in the new XTreme magazine.

I believe that was taken at the Winternats? A couple of reporters took a few snaps of the engines there. Must go down and get the new Xtreme mag. Thanks.

Edward... I cant respond to your PM... your mailbox is full!!!

Hi,Edward...
sent you mail.....(subject,BRB Set) ...........Luis.

What Page??? I can't seem to find it...

It's in the article about the winternats, lower left page

Thanks a lot for good words.
Unfortunately I don't have dyno to test the egine. I asked around all big guys ( engine modifiers and manufacturers in LA) and so far nobody has dyno to test it.
I ofer two mags on Winternats to teste it, but so far nobody responded yet. May be I should ask Novarossi to test it for me, also they will have chance to make drawings from it withut buying it.
On new version of engine we changed couple things which aren't that major, but defenetly will improve performance further-rear bearing we use now isn't 12x21 mm, it is initialy 9x20, but inner ring we remove it and bals are running in cranck dirrect ( we made special race track for bals). Reason for it is balls on this bearing are little bit bigger, which make this bearing 3 times more handeling load ( life too), also it is wider and we ground one side to fit in standart side-so now we have wider base distance between bearings which makes cranck more stable ( it as done in the past many times and resuts are just great). Also new technology came during we makes prototypes ( P/S ste ups ) and new engines already have new set ups.
So we are execting eve better results to compare with prototypes.
I will try to make pics today of this changes and will put them here.

I cleaned already, getting to fast full.

Sets are not here yet, expecting to have them some time on end of this week or next week

Hi,Edward
please let me know as soon as they arrive....

OOHHH...i forgot to ask if you have any Engines available
please let me know....Thanks..Luis.

gimme gimme gimme!!!! please!?! I can't wait!