353 09
 

Im looking for an online store that sells piston/sleeve set for the nova 353 09.
(store must ship international)

any recommendations

Manifolds.
 

Hi guys,

Which type of manifold is better..Conical or Non-Conical?:confused:

from what i have learned....
conical = different diameter at each opening,more power which uses more fuel.
non conical =standard, better fuel economy and less power.

Thanks for the info

Can anyone help me out with some info on the flash .12-3port.

Would like to know the racing temperatures of this engine, glowplug I should use. percent nitro fuel I should use... etc.

http://www.rc-toro.com/product_info....oducts_id=1487

here you go

Anyone know the front bearing size for novaroasi 359 tune? Thanks.

Running-in procedure
 

This is most probably a well worn topic by now, but I keen to here from anyone regarding the best way to run-in a Nova Flash .12. I would normally give the car two tanks on the bench using 15% castor no nitro and then run the car on the track with a rich setting for about 6 tanks then start leaning it out. By about tank 10 I would switch to race blend fuel and continue till race tune is reached.
One of our most experienced races prefers to do 1 tank on the bench ( race blend fuel) then tune the car just off race settings and run for approx 10 mins using the throttle to hold the engine back ( rather than a rich setting). After that it's tune to race settings and drive the car.
What procedure are you guy's using out there, that gives a well run-in engine, good power and longevity.

Can u guys give an opinion about the Kangaroo engine? I am looking into getting back to racing and this engine looks like has the right price

hi, thinking of getting a conical header for my rb tj10 (modified) with 2604 pipe.

i run on a fairly small/mid track, which one do you think is best suited?

5 or 6fin?

Can anibody tell me what's the technicall difference between the .12 Flash and 353 .12/C Tuned? Which motor is the top runner of Novarossi? Maybe the 353? It has better characteristics on Novarossi homepage!?

Regards, Lojz

Hey guys,

I am looking for a RB .12 Crankcase (R3/T9/T10/M3). Please let me know if you have one lying around in your pit box.

Thanks.

i do have one but it's got a chip down through the carburetor hole i haven't tested it so that it would give me any probelms

Do you have any pics??

How did that happen?