Originally Posted by Wheelie master (Post 10794133)

Has anyone found their BTTs running well over 300 deg? my engine wont run rt unless its around 310 deg.. its puffs out a bunch of smoke on the initial throttle pull and then i still seem smoke as its running down the straight. but yet if i lean out the bottom it runs on and if I richen it on the hsn no more then an hr or 2 it sounds like its drowning in fuel..

i use the 6.5 insert and power masters fuel in a serpent. is this fuel any good?

Originally Posted by Maximo (Post 10794227)

then spray nitro spray

Originally Posted by TX_Punisher (Post 10794238)

Is that a Canadian product? :blush:

Never heard of the stuff.

Originally Posted by Wheelie master (Post 10794133)

Has anyone found their BTTs running well over 300 deg? my engine wont run rt unless its around 310 deg.. its puffs out a bunch of smoke on the initial throttle pull and then i still seem smoke as its running down the straight. but yet if i lean out the bottom it runs on and if I richen it on the hsn no more then an hr or 2 it sounds like its drowning in fuel..

i use the 6.5 insert and power masters fuel in a serpent. is this fuel any good?

Originally Posted by Maximo (Post 10794227)

do a little test....fire your engine up on the starter box, get it to a steady idle, then spray nitro spray right behind the flywheel...just a little spritz....see if the engine stalls or not.........

Originally Posted by Ginters (Post 10793163)

Hey all,

Just a quickie really,

Running a nova plus 4 btt in a MP9, using a 9901 pipe and 41021 header with a c6tg plug jvd clutch and 13t bell.

My endpoints are set and the carb doesnt fully open 6.5m venturi running 25% fuel.

Now my query, I have the idle gap set a 0.6m so thats good.

At the weekend is was hot and my engine wouldn't settle nicely on a idle no matter what i did went rich LSN then Leaner LSN no change richened out the top and repeated etc...

It ran but wasn't purring, also after 7.5mins i was on vapour! Now the engine is around 22 tanks old now. Always preheat before starting too.

I tried the base settings that i got off here and that was way too lean was running on just on the box so just some points to clarify -

Base settings for the engine?

what sort of tune are people putting on these I'm not an expert at tuning but I've got a rough idea which is why sunday was so strange?

my HSN is 3.75 out

LSN is 5 1/2 out..

Originally Posted by Ginters (Post 10794201)

its piranha fuel distributed by Nemo racing in UK (agama,beta,bullit stuff)

Sorry i forgot that bit!

Originally Posted by Ginters (Post 10793163)

Hey all,

Just a quickie really,

Running a nova plus 4 btt in a MP9, using a 9901 pipe and 41021 header with a c6tg plug jvd clutch and 13t bell.

My endpoints are set and the carb doesnt fully open 6.5m venturi running 25% fuel.

Now my query, I have the idle gap set a 0.6m so thats good.

At the weekend is was hot and my engine wouldn't settle nicely on a idle no matter what i did went rich LSN then Leaner LSN no change richened out the top and repeated etc...

It ran but wasn't purring, also after 7.5mins i was on vapour! Now the engine is around 22 tanks old now. Always preheat before starting too.

I tried the base settings that i got off here and that was way too lean was running on just on the box so just some points to clarify -

Base settings for the engine?

what sort of tune are people putting on these I'm not an expert at tuning but I've got a rough idea which is why sunday was so strange?

my HSN is 3.75 out

LSN is 5 1/2 out..

Originally Posted by jnorwood_losi (Post 10794460)

Just for reference, what does this do?

Originally Posted by jnorwood_losi (Post 10794471)

I dont know where my HSN is from FLUSH, but because I heard someone talking about the "PERFECT" LSN, I check mine just the other day and it was 4.1 - 4.2 out from flush, and what I heard was optimal 4 - 4.25

Originally Posted by houston (Post 10794488)

you're dialed brotha:nod: