huh?

if you heated it up enough it should turnover on that box just fine

gel cell ? if so make sure it is charged with low ampreage for a while - .6 amps for 24 hrs. :)\

btw , i dig the vroom vroom :lol: i often do that with the newly built mills :nod:

No, I think the box is shot, I had trouble with it last week with a worn out RB.

replace/rewire the motors and all is well..may as well go all out and do low/zero-resistance wiring/connectors as well ;)

sup Monty! can u say bling? :lol:

thanks brudda'

I redone it last week when I was having problems and put in a new power panel and sodered (sp) all the wires. It has the 12v gel cell that has a charge of 12.89v. I am thinking the brushes on the big motor are shot, waiting on my Mugen box now, wish it would hurry, wanna see this puppy run

i guarantee you wont be disapointed :nod:


get yourself a lipo or two 7.2v stick packs :nod: you will be much happier and lighter ;)

I got a Reedy 4S Lipo coming with the box:nod:

Hey Monty
i have a nova 821b, i think it will need a piston and sleeve
since no one carries them anymore do you know of any other piston and sleeve i can use?

;) pm me

Monty, can you tell me the needle settings for a 528X? Would they be the same as my P5X? I'm 3 3/4 out on low and about flush on top with the P5 and it's about perfect. Just having some issues with this 528 I have. Thanks!

.28's usually are a little more open on the needles , like 4-4.25 on the low and around the same on the high


they have different carbs though too , remember that ;)

Thanks Monty!

look here for carb settings..
http://www.fusionmotorsports.com/BasicCarbSettings.html

Thanks for that too! I bookmarked that page. :)

can u say braaaaaapp?
Purple Power Baby!!

thanks as always Monty..........HES brings me service at its best ;)


they are from L to R:
Plus4 turbo with Sirio 2013 pipeset, Odonnell head and 97t plug

21-7BT turbo "Houston Tuned" sleeve and crank, Boca ceramics F&R, Ofna 053 pipeset, Odonnell head and 97t plug

P5XS standard w/ plus carb, Rex 9886 pipe w/ Dynamite smooth flow header, Odonnell head and 100 plug
http://i50.photobucket.com/albums/f3...Picture007.jpg

whoa im jealous