Check carbs tight , gaskets arent leaking , basically clean engine off completely before running if you see a wet spot when youre done guess what you found ;)

Novarossi P3xs Internals
 

Hello Mr Houston:

Been looking online for Piston / sleeve combo and a new shaft for my P3xs and cant seem to find any that I 'know' will work in it.

Do you know of anyone know who sells parts for this engine? Also any recommended bearings since they seem okay still, but I may replace them also. Very hard to find online. Everything seems to be P5 nowadays.

Thanking you in advance for your time

all parts from p5xlt will fit in that engine

That's pretty much the entire engine. Wouldnt it be cheaper to buy the entire thing, rather than just internals

That would be my suggestion Chad

Houston.

I also have a P5xlt. How do you tell if you have the newer front bearing?

Look on exploded view and if unsure still take a pic and send it to me

[email protected]

Thank you sir. And it is the updated.

My Fusion X3 is faster than yours

my x5 is faster then your x3 :D

I like rc cars

overachiever lol

Fusion Engines + Racing with Monty = Awes:nod:me

Definitely good times Jason !

Dont forget about Montys Meat Magnificence :)

Quick question. Does it matter if you do or don't run a washer in front of the front bearing before the flywheel collet goes on? The reason I ask is because I am using a washer but it has made my flywheel move forward and know I need to use an extension lipped washer on the clutch bell to get the right free play and it is close to my tank.

Hope this makes sense