Hey guys just bought a blast v11 for my Losi 8ight T truggy. Anything I should know about it?

It's meant to be more or less made from B10 parts - i.e. a good engine. Can't tell you more than that. I'm keen to hear how it is though... I got the V9, but won't get to break it in any time soon. The first few reports here seemed pretty good(any more?) The Blasts are basically RB using up all their old high end parts...

Sounds pretty good to me haha. I grabbed two since they are limited edition. Ill let you guys know after i get them broken in

did your run your blast v11 yet ?

Hey guys i bought this engine yesterday. Has any one run theirs yet ??
Rb blast v11

I just bought the blast vll and tuned pipe combo from amain with 10% off discount code ! thinking it will be perfect for my new 8ight 3.0 kit without ripping my wallet apart! and imput on this mill i see they are selling quick from the posts above mine

Does anyone know what parts RB has put in their Blast V12?

There's a V12? Link?

Been looking at the v11, never knew much about it, so i started comparing parts numbers to older rb engines..looks very similar to the old c6 series...same crankshaft, bearings, carb, sleeve is 5+2 bypass just like the c6, bore is 16.22 and stroke 16.80 just like the c6, crank is 14mm biturbo just like the c6. Im comparing it to the c6 cause that has got to be my favorite buggy engine of all time. Tons and tons of power down low, gets to top rpm fast, and is plenty fast for the straights. Seeing as the c6 hasbt been made for quite some time and i need a new engine, the v11 seems like a great deal.

Blast V11 is about to be my race engine. I have zero exp with RB though...

Prolly start breaking it in this weekend... Expecting good things.

Blastv11 same as nova Beat 5 ? looks identical specs witch i like ...long stroke 5 ports are awesome

The Beat 5 is identical to a P5XLT I thought..

If the V11 is really all that, I might try harder to sell my V9(new and unused) to get one.. From what I understand, the V9 is more of a tame-ish buggy engine - supposedly with C5 internals..

Bearing
 

I have an old RB 5 port. Although the front bearing has finally worn out the compression is still good, so I'm debating whether it's cost effective to replace the bearing. Who makes good bearings? Information on bearing pullers? Thanks everyone

TKO Makes a good bearing that will fit. The bearing puller I like is the ofna one.