My ExTech is leaking alot around the carb, I mean alot...almost streaming out around the carb or carb boot. I sealed the carb with Lucky 7 and it still leaks, I removed the carb boot and very carefully cleaned eveything and made sure it was seated perfect but haven't tried it yet to see if that helps. It's also getting very notchy in the cold weather, everything is fine then from one heat to the next the top hits hard and it's difficult to drive. I have to richen the top alot to calm it down. I don't dislike the motor I just wish it didn't leak so bad and wasn't so notchy. I haven't had these problems with my Novarossi or even my low budget VG.

;)

Thanks, I'll check that. It's not wet on the boot itself but at the base of the boot and below the carb, and only on the boot side of the carb. The other side is dry.

;)

TEUFEL - shipped yours back yesterday! looks good put notes in there

KYJOE - if you sent it back and ill take care of it!

I run a TTR pipe of amain 2035 or something at 30.00
and P3 os plugs

Thank you, I'll do that. Chad, could you PM me with your work number and I'll call you monday to get shipping info. thanks again

I have 2 packages here with no return address. They both came from shipping stores.. One package is from Illinois and the other from Virginia.. contact me at [email protected] to identy your item so it can be returned to you. thanks :)

I just got my extech 21 pre -run :nod:.. But im having problem pulling the carb out to tight :cry:. ...Pull turn pull turn...

You can send those both to me Chad ;)

pinoy - check the clinch bolt.. it may be tight :)

no its not i took the right side off.. Im almost there half way:nod:

do you have both sides loose? i know on other engines if i leave one side tight it will still be stuck, i usually have to press in when i am threading the bolt out to get the other side to come out

I pushed it out a little bit.

Finally its out ...:).. I cant wait to go home lols

whats the best pipe for the .21 eb modded? hows the new 2056 compared to the 2013, 086 etc. power and runtime thanks