I will save you all so pain and go to the nube spot

who ever you need to post pics for, send them in email. not sure how many posts you need.

http://i469.photobucket.com/albums/r.../GoTeck002.jpg
Bad pics

Do you have to re-tune when switch to a smaller venturi (sp). I went from the 8 to the 7.

Yes you have to retune your getting less air just my 2 cents. Back to me I have been using the os carb.

1.1mm springs

what color would that be in losi set-up?

dont know about losi... i run xray 808 with a vppro clutch. which is a hard clutch set-up

ok, hopefully a losi fan will chime in soon! lol

well if it goes in this sort of order: soft, medium, hard. get hards

will do!:)

if you can. get vppro shoes. and xray xtra hard springs. the go motors love them

The VP shoes won't fit the Losi 4 shoe clutch, nor will the X-Ray extra hard springs - but I know what you mean. I used the X-Ray extra hard springs and the X-Ray 1.71 alloy shoes on my 7 Port, awesome combo. Gone to the Ascendency 4 shoe now on the X-Ray with the gold 1.0 springs. The Ascendency springs are stronger and the 1.0's are just right on the 7 port, 3 port and MG66 for that snappy bottom without too much wheel spin.



Inferno13 - Losi springs: run 4 x gold springs and see how you go. If you need more snap off the mark run 4 x silvers.

Losi spring chart, straight off A-Main
Silver: .040 wire with 30 degree angle
Gold: .040 wire with 25 degree angle
Black: .036 wire with 30 degree angle
Green: .036 wire with 25 degree angle



BigBOSS - you have a Gen 5.5 7 Port there.

Thank You. Now all I need is to find all my parts.