I like cutoffs up front with madrunners in the rear= the ultimate combo.

anybody tried the new EBM5?

Is that an engine that racefactor is gonna support or is it EB only??

Check out the most recent graphs of the M5 at www.ebmods.com

I've seen them, impressive thats why I wanna get my hands on one... anyone know the price?

http://www.rcplanet.com/EBMods_M5_Fu...r21ebm5-fm.htm

http://www.rcplanet.com/EBMods_M5_Ra...r21ebm5-rp.htm

Thanks

No problem! if anybody ever needs help with any EB Mods products, i'm always here to help. ;)

so whats the hot pipe for the 3port turbo .21 on a med size track?

Well I've been runnin the EB VZB's for a year now, best motor we've ran in over 8 years... now that those are gone we wanna continue with what EB has to offer...

GO FEMCA 0801 will do the trick.

Good to hear! I think you'll be very pleased with the M5. :nod:

MMMM :nod:2047 with 0801 header still my favourite wish I hadn't told you about it now everyone knows:lol:

Adrian;)

Retro RC, are you using that combo on a 5 or 7 port, what run times are you getting? how does the powerband feel?

I will be ordering my race prepped version with an EB 2041 pipeset next week. I got my EB Mods Race 30% fuel already, so when the mill comes, gonna be some serious braappppin bout' to happen:lol::lol::lol: I wanna make sure I get the right pipe to keep it smooth and easy to drive so is the 2041 the right choice, I have an 086 as well I could use, Is Ed going to make a specific pipeset for this mill in the future? Also what plugs have you found to be best for the EBm5 Joe? cheers!! TW

pwnzor, the 2041 is not the best pipe for the Go engines, i would reccomend the 086. but the best pipe out right now is the Go femca 801.