Serpent 710
Originally Posted by rangulo
Serpent/Mega to win the winternats.....
Originally Posted by rangulo
Has any one seen the solid axle being used in a race....
We tried them in Hk but gear diff is way to go.
no need to go too far to look for advantage.
Originally Posted by rangulo
Has any one seen the solid axle being used in a race....
Does anyone know if the rear axle from the Impulse Pro can be coverted for use in the 710?
i don"t think so the car are so different. 710 ins narrower in the front and rear
Tech Fanatic
FT MYERS SETUP
Hi Guys,
Attached you will find the setup for the S-710 for Ft. Myers
Paolo
Hi Guys,
Attached you will find the setup for the S-710 for Ft. Myers
Paolo
paolo you have PM
Originally Posted by Paolo M
FT MYERS SETUP
Hi Guys,
Attached you will find the setup for the S-710 for Ft. Myers
Paolo
Hi Guys,
Attached you will find the setup for the S-710 for Ft. Myers
Paolo
Where can I get a blank sheet of this please?
710 team car
on eliterc website showing a serpent 710 team car # 802006. is this the so called new 710 ? looked on serpent website and they do not list the part number.
nothing different just few hop-ups.
nothing different just few hop-ups.
Originally Posted by kitracer
Hi guys,
Where can I get a blank sheet of this please?
Where can I get a blank sheet of this please?
See link: http://www.mytsn.com/products/downlds.asp?prid=3293
Tech Rookie
Originally Posted by phantom-racing
on eliterc website showing a serpent 710 team car # 802006. is this the so called new 710 ? looked on serpent website and they do not list the part number.
nothing different just few hop-ups.
nothing different just few hop-ups.
Tech Initiate
Blank Setup Sheet (pdf)
Originally Posted by kitracer
Hi guys,
Where can I get a blank sheet of this please?
Where can I get a blank sheet of this please?
http://www.supashare.com/91545390/
I'm fairly new to RC and I'm making a new Mazda 6 body for my 710, but I have a little problem. I'm trying to make the holes for the body post but the 2 rear ones seem to be too far back. They actually touch the edge of where the wing sits. So I'm just wondering if I do anything wrong here
Originally Posted by Xyvern
I'm fairly new to RC and I'm making a new Mazda 6 body for my 710, but I have a little problem. I'm trying to make the holes for the body post but the 2 rear ones seem to be too far back. They actually touch the edge of where the wing sits. So I'm just wondering if I do anything wrong here
Originally Posted by Xyvern
I'm fairly new to RC and I'm making a new Mazda 6 body for my 710, but I have a little problem. I'm trying to make the holes for the body post but the 2 rear ones seem to be too far back. They actually touch the edge of where the wing sits. So I'm just wondering if I do anything wrong here