why this protection? go so slow? :-) (Joke)

come on boys have we fixed them so good that no one has anything to say my grandson put his 5 on shelf after nats/aus till QLD next month cause he bid not want to were it out he has saved pop a $$$$ +he has a real car had to spend his own money on petrol nearly made him cry
greg

The mtx5 is working really well now, so it's all about fine tuning the car to give me what I want. Great car!

I see the USA is still with us you lot haven't stops shooting each other yet they whinge about the road toll but you lot love your guns puts the road toll to shame its raining again sunday glad to see your 5 is aright you can see I am board to death

After every race i have to refill my diffs....what can i do to stop the leaking???

pump all the air bubbles out before you close the diff up

I use a tiny thin bit of blue gasket sealant on the gasket and had very little spillage

http://www.ebay.com.au/itm/Mugen-Sei...item3a82225a75

JJ's latest MTX5 setup sheet from 2013 Byron Nitro Challenge
http://www.jjwangracing.com/setup-sheets-nitro/

JJ's latest MTX5 setup sheet from 2013 Byron Nitro Challenge
http://www.jjwangracing.com/setup-sheets-nitro/

Well it's great to see Robert doing well in the Euro Nitro Series.
Both in 1/8 & 1/10.
Great work mate.
I was keen to see what if any trick bits he's running and I like to see his setup data after this race.
I had a look at the photos of his MTX5 and saw a few neat tricks and see if you guys can spot them.
Front diff, original style chassis with some extra holes, maybe an new engine mount hole pattern, small receiver battery, springs? check out the rears.
I see he is still using his carbon cross brace but no rear brace as many are using.

Really good to see an MTX5 back in the top listing all the best for tommrow Robert.

Steve H

Could Mugen do something similar to what Hot Bodies have done with their R10 and brace the rear bulkheads to the engine mount?

Did you notice Robert's brace along side the two speed shaft?
http://ens.redrc.net/wp-content/uplo...06/Sat_cf4.jpg

what kind of battery do you think he is running?

Did you see that set screw on the front diff? bleeder maybe?
http://ens.redrc.net/wp-content/uplo...06/Sat_cf7.jpg

the brace is an old one which some drivers are already using since last year.