HB Racing D819 Nitro Buggy
#107
The kit was suppose to ship with a set of long and a set of short. Instead the first run shipped with 4 short.
#108
Tech Rookie
#109
I ran into the same problem, built the car and couldn’t figure out why I couldn’t get the droop from the setup sheets.
#111
Tech Adept
I have just bought the D819 driveline, i have heard that the front dogbone can pop out. Is anyone having this problem?
#112
Just put a shock oring or two in the front cup or some fuel tubing.
#113
#114
Tech Adept
It frees up the drive train a bit,which helps the car carry more corner speed and spool up quicker out of a corner. Ive just converted my car and i couldn't feel any difference but my lap times were a fraction quicker. The slimmer front hubs definately make the car turn in quicker,i found i had to go down in the shock oils as well.
#115
It frees up the drive train a bit,which helps the car carry more corner speed and spool up quicker out of a corner. Ive just converted my car and i couldn't feel any difference but my lap times were a fraction quicker. The slimmer front hubs definately make the car turn in quicker,i found i had to go down in the shock oils as well.
Times don't like lie.
#116
The drivetrain is much smoother and more free!
#117
built several D817 kits and never was missing one screw or part. Built one D819 and was missing a few screws, and had the wrong rear shock ends. I am sure the factory will clean this up, just first runs to get the kit out always suffer.
#119
Anybody try the fasTrace shock caps and bladders yet?