NEW XRAY T2
#4231
Tech Apprentice
check the Xray site. In the set-up sheets section you will find some from the DHI cup in Denmark. I think that would be a good starting point.
#4234
Here is the link a for some pics of jilles' t2
http://www.rctouring.nl/X-Ray%20T2%2...20Groskamp.htm
http://www.rctouring.nl/X-Ray%20T2%2...20Groskamp.htm
#4235
Anyone know where can I get a set of snap-ring pliers small enough for the T2 diff? I tried two local tool stores before work today with no luck.
#4236
Is there a mod that needs to be done to run LiPoly batteries in the T2?
#4237
Tech Fanatic
iTrader: (33)
Nexus.. I got a nice pair at my Local sears Hardware store..
Superfly.. You have to file down that one part on the rear aluminum bulkhead that hangs down. It has been done successfully.
I have a question. Last night I was at the track and borrowed those chassis balancing things. My friend with the same car had to add 10 grams of weight on the battery side for it to be balanced.
When we did mine I needed like 30 grams of weight on the other side where the motor is. Its just weird to see that big of a diffrence. I mean I do have smaller electronics than him but that is a big diffrence. And when I look at all the pro drivers set-ups they add weight on the battery side to. Anyone have any idea's?Where have you guys put your weights?
Superfly.. You have to file down that one part on the rear aluminum bulkhead that hangs down. It has been done successfully.
I have a question. Last night I was at the track and borrowed those chassis balancing things. My friend with the same car had to add 10 grams of weight on the battery side for it to be balanced.
When we did mine I needed like 30 grams of weight on the other side where the motor is. Its just weird to see that big of a diffrence. I mean I do have smaller electronics than him but that is a big diffrence. And when I look at all the pro drivers set-ups they add weight on the battery side to. Anyone have any idea's?Where have you guys put your weights?
#4239
My car is so hooked up right now....
and I'm even running purple and plaid tires. It's great! I'm lovin this car.
#4240
Originally Posted by Nexus Racing
Anyone know where can I get a set of snap-ring pliers small enough for the T2 diff? I tried two local tool stores before work today with no luck.
#4241
hey guys does anybody know where you can find the solid top deck for the t2. if so let me know thanx.
#4242
Tech Master
iTrader: (3)
Squaring Fixture
Here is a little something I have been working on for awhile. I’ve had the idea for a few years and I think the T2 can really benefit from it. It’s a squaring fixture designed to perfectly square the T2 front to rear, side to side, and corner to corner. I designed it to accommodate screws going all the way through the bottom. The battery taping area, the lower bell crank area,and the servo mounting screw sections are pocketed so the chassis can rest perfectly flat with no obstruction. Just take a completely assembled T2 ready to go on the track and bolt it to the fixture using the 4 weight screw holes on the chassis corners. Then loosen all the top plate, bulkhead, diff cover, etc, etc, screws and re-tighten them. It works very well. It has a 3mm ledge around the outside so you can use it as a car stand. The unit shown is just the prototype. The production version will have 3-inch long thumbscrews to fasten the car to the plate. Let me know what you guys think.
Last edited by Art Jensen; 04-02-2006 at 06:11 PM.
#4244
Tech Initiate
Top deck
CRC has the solid decks. They work great!