NEW XRAY T2
#5866
Im probably on medium to low bite...
indoor offroad causes alot of fuzz and loose areas.
Anyhelp is appreciated.
Thanks
indoor offroad causes alot of fuzz and loose areas.
Anyhelp is appreciated.
Thanks
#5867
no input?
#5868
Not sure how it will do on carpet, but this is pretty close to the set-up I am running on low-bite asphalt.. Obviously not running CS27s, but chassis stuff is close to the same.
http://forum.teamxray.com/xform/inde...=1655&setup=t2
http://forum.teamxray.com/xform/inde...=1655&setup=t2
#5869
Now Available!
Questions/Interest PM or visit my thread.
X-Ray T2 Chassis Protector For #301118, #301121, #301122 & #301123 Chassis.
Please Note #301118 & #301122 require 2 holes to be cut out.
Questions/Interest PM or visit my thread.
X-Ray T2 Chassis Protector For #301118, #301121, #301122 & #301123 Chassis.
Please Note #301118 & #301122 require 2 holes to be cut out.
#5870
subscribed..
#5871
anyone still runnning the T2?
#5872
I may have had my bumper installed improperly in the first place.Didnt have the two screw in there.
the fix. mounted on the bulk heads and had to recut body holes.
I drove to far and lost my radio signal. I tried and was on the brake, but i went into the sidewalk i gues pretty fast running a 5.5t. It cudnt have been full speed since i was on the brake, but i think the thing accelerates when the signal is lost as well. Shud of known better, and had my failsafe set.
the fix. mounted on the bulk heads and had to recut body holes.
I drove to far and lost my radio signal. I tried and was on the brake, but i went into the sidewalk i gues pretty fast running a 5.5t. It cudnt have been full speed since i was on the brake, but i think the thing accelerates when the signal is lost as well. Shud of known better, and had my failsafe set.