Hot Bodies Cyclone
#9541
Tech Elite
iTrader: (63)
???
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
#9542
#9543
???
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
#9545
spacers under pivot blocks
now my hara cyclone did not come with any pivot blocks spacers. but when i check hara and andy setup sheets i see they are using them what effect do they have on the handling and what is a good starting point for asphalt.thanks
#9547
anybody has the part # for the center shaft not the one way.
#9548
Tech Rookie
#9549
???
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
Is a diff to tight or to loose when you hold the spur gear and one back wheel fixed, and try to turn the other back wheel and it turns but is reasonably hard to turn........
or is this just right???
i specificaly wanted to know how it should feel when the diff is in a totally assembled car..
thanks......
Try to build it so the diff action is super smooth and free but its nearly impossible to get it to slip. I run mine so it slips right before the rear belt skips
#9550
#9551
hey are takeoff rubber tires like 63mm?
#9552
Tech Regular
iTrader: (17)
Hey Guys, I have a post in the wanted section for a Hot Bodies Cyclone. If any body has one for sale, please post in my ad in the wanted section, or email me at [email protected]
Thanks Chico.
Thanks Chico.
#9554
#9555
Help me out guys
I am going to race brushed 19turn (not BL and 5 cell yet) And I used to race stock
What from my set up should I change? I was running BL stock, Cant afford a 10.5 yet
Thanks
I am going to race brushed 19turn (not BL and 5 cell yet) And I used to race stock
What from my set up should I change? I was running BL stock, Cant afford a 10.5 yet
Thanks