3 racing new F1
#2551
#2553
Tech Champion
#2554
Tech Initiate
it looks very coooooool!
#2557
At this point it's best for 3Racing to come out with a bigger Center gear and smaller diff gear to reduce the 2.71 internal ratio that hurts top speed Performance. They can also try to switch to 48p gearing instead of those big noisy gears....
#2558
Tech Regular
64 pitch would be even better.....and for fine tuning for that "just right" gearing that is sometimes needed.
#2559
Tech Champion
iTrader: (17)
Hears an idea for the belt drive:
3Racing is showing their all new line of 4mm ID shaft pulleys. Use the stock lay shaft with a PRS adapter from the JRX-S on it and one of those new pulleys in the middle. They clamp down with a set screw/screws, so centering the belt would be easy. It would be nice if it could work with the pin holes already in the shaft to anchor the pulley better, but not really an issue. Then use 3Racing's diff case with pulley instead of the gear drive or their ball diff with pulley. That eliminates the rotation reverse gear. Those layshaft pulleys come in sizes from 12 to 28 teeth. The only issue is finding a belt that small. Maybe the ABC goose rear belt would work?
Make sense?
3Racing is showing their all new line of 4mm ID shaft pulleys. Use the stock lay shaft with a PRS adapter from the JRX-S on it and one of those new pulleys in the middle. They clamp down with a set screw/screws, so centering the belt would be easy. It would be nice if it could work with the pin holes already in the shaft to anchor the pulley better, but not really an issue. Then use 3Racing's diff case with pulley instead of the gear drive or their ball diff with pulley. That eliminates the rotation reverse gear. Those layshaft pulleys come in sizes from 12 to 28 teeth. The only issue is finding a belt that small. Maybe the ABC goose rear belt would work?
Make sense?
#2560
64pitch is too weak for internals that are exposed to dirt and debris. I do agree that it would give better efficiency and gearing choices though.....
#2561
Tech Master
64dp is fine. I have ran 64dp for years in touring cars with exposed gears powered by silly fast motors, and have never had any issues with them.
#2562
Tech Champion
iTrader: (17)
Somehow I don't think your thinking spur and pinion. The others won't matter for a belt drive as all TC belts and pulleys run the same pitch belts for a belt drive. The large teeth on the stock setup from counter rotation gear, shaft gear, diff gear isn't noisy at all. The sound is unique though.
#2563
Tech Master
if you have excessive noise check your diff for roundness of the gear. Mine was warped and caused a ton of noise. Switched to the ball diff and it was a ton quieter.
#2564
The gears are 48 pitch. they may be metric but I use standard 48 pitch pinions with no problem. If you have top speed issues then be sure you have the 35 tooth spur. I can keep up with any f104 easy. you may have to grind the motor mount and move the top deck post but the speed is there. Mantis has run a 38 tooth pinion on his. I run a 31 and its plenty fast for all but the largest straight.
if you have excessive noise check your diff for roundness of the gear. Mine was warped and caused a ton of noise. Switched to the ball diff and it was a ton quieter.
if you have excessive noise check your diff for roundness of the gear. Mine was warped and caused a ton of noise. Switched to the ball diff and it was a ton quieter.
+1 i have no top end issues either!