terry the rear fit`s in the front !! no prob`s

also a yoko SD diff bar the crown gear & 6mm diff balls fit also
i find the yoko thrust assy & diff screww alot better then the weedy tamiya one

Glad it helps terry :)

oops! quite right, my mistake, it does fit. During the build I just compared the overall lenght including the outdrives, should have been more patient :o

Know what you mean mate, after building Xray diffs the last couple of years I was surprised at how weedy the tamiya one seemed. Although I must admit it has gone together super smooth, I havn't run it yet though so will see how long it lasts before a rebuild.

Sure did Ed :nod: Guess what, your site is now saved in my favs :nod:

MS 4Sale
 

Anyone interested I have an "MS" 4sale $200 shipped lower 48.
roller chassis and oneway. :p excellent condition pics in the 4sale forum search MS

Pm if interested. No trades Please. :eek:

Thanks, Guys and Gals :D

You can't search for "MS"...not enough characters. :) Trust me...try M8...LOL

my new Evo IV MS
 

well i finally have my Evo IV MS. ready to rumble. it will hit our club track for the first time this sunday!! i can't wait to give this thing a run!!!

Specs: ESC - Novak GTX
Motor - Tamiya Dyna Run 13x2
Batt - Nosram Big Mama 4200 Factory Team
Tyres - Tamiya Type A - Medim Insert
Body - Protoform Mazda 6 200mm

I have tidied up the wiring since the pics were taken. the battery connector now runs under the top deck and the motor leads are much shorter. it looks alot neater now

http://i60.photobucket.com/albums/h4...er/evoms15.jpg
http://i60.photobucket.com/albums/h4...er/evoms25.jpg
http://i60.photobucket.com/albums/h4...er/evoms22.jpg
http://i60.photobucket.com/albums/h4...er/evoms13.jpg
http://i60.photobucket.com/albums/h4...er/evoms17.jpg

Looks very nice!

Good luck for your first outing with your car!

well...it ran like a dream!!! fist qualifier was more a shake down run. i took it easy. the car ran well. after that i just let loose. TQ'd and won the final. boy was i chaffed!!

1 question now. i will be running a 7x2 Team Brood V2 motor. what gearing would you guys suggest? Tamiya Type A tyres. below is a picture of the track that i race on.

http://i60.photobucket.com/albums/h4...ck_599x375.gif

i need help setting up my evo 4ms ive never raced it on asphalt i just need a few pointers i ran it today and no matter what i tried i couldnt stop the rear end from sending me into a full on drift i ended up turning the steering travel down low it helped a bit but it still is to hard to drive fast (running 27 sometimes 19)

what is the size of the screw that goes on the bottom side of the c hub into the hub ive lost both and i aint got a manual to see the sizes to order some more :cry:

Here ya go bud. Ask Mt Jolly on this site, he's a bit of a genius on setup :nod:

Here ya go bud http://tamiya.com/english/rc/rcmanual/tbevo4ms.pdf Ask Mt Jolly on this site, he's a bit of a genius on setup :nod:

What size pinion and spur gear would you guys recommend for my evo IV MS running a Novak GTB 4.5 looking at long runtimes and another setup for high speed runs