Advanced Electronics Black Diamond ESC
#841
Anyone tried one with a Speed Passion MMM motor?
I've been suing a Reedy which has been OK, but I have trouble finding that sweet spot.
Skiddins
I've been suing a Reedy which has been OK, but I have trouble finding that sweet spot.
Skiddins
#842
Tech Initiate
Finally found the sweet spot for the bd in 17.5 open in oval. Posted fastest lap time in that class and fell off 2 tenths throughout a 5 min run. awesome!
#844
Tech Initiate
I run on a small 85 ft bullring. I rolled out at 3.23 and pulled about 22 amps free spin wit ha novak ballistic.
Hope this helps
Hope this helps
#845
Anyone got any setups for the BD when running 1s lipo's in either a 1/12 or WGT?
Skiddins
Skiddins
#847
#848
#849
Anyone managed to get an LRP x12 motor to run well with the BD, without melting it
#851
Anyone know what's happening with Advanced? CRC has removed them from their site and so has Stormer.
#853
#855
I'll post this as I asked AE directly what the red 'error' flashes mean;
Red ERROR flash:
1 = No rx signal
2 = Temperature too high (above set value)
3 = Too low battery voltage
4 = Motor sensor problem (faulty sensor wire or the sensor in motor is damaged).
I'm also in contact about tuning and various settings for 2s TC but haven't had a chance to test anything yet.
Red ERROR flash:
1 = No rx signal
2 = Temperature too high (above set value)
3 = Too low battery voltage
4 = Motor sensor problem (faulty sensor wire or the sensor in motor is damaged).
I'm also in contact about tuning and various settings for 2s TC but haven't had a chance to test anything yet.