DOTMAN

iTrader: (5)

RCInfinity (Neal) - would you happen to know Patrick's SoCal Mod setup? I'd like to run my EVO2 in mod and would like a good starting point. Judging from the results on Socal's website, his setup must be pretty good. He finished only six seconds behind Kinwald

Neil Rabara

Hey Dotman

That's a good question. Next time I see him, I'll ask him for his setup. He doesn't come up to Socal too often. But when he does, he can definitely perform. However, from what I remember, he still runs the PB suspension, and he gave me some pointers on setup that actually worked.

DOTMAN

iTrader: (5)

That's cool. That will save me some time. I use the Pivot Ball suspension too. Thanks for your help

redsand

Would you mind sharing that PB suspension setup with me too ?

AssociatedRacer

hey, should I get a T1R or save up for Evo2? this is for socal...

Rc-Iceman

Hey there guys.

Look info: www.rczone.net

Anyone know when we can get those new center 18t pullies and f/r diffpullies?

What is new ratio vs old 2.125 with those newbies??

Sorry if there was old discuss before that.

Thanks

Ice

Caddzilla

With a 18t center pully the new ratio is 1.888.

Proto pilot

Wow -1.888- vs 1.125!!! How about if i want to change my spurgear and pinjon system, is it hard to find the right thing if the motorcan get closer and belt sweep the can. I mean, when i `ll go race to big track... is it problem?

Elk666

actually it's 2.125 and not 1.125

on another note yesterday i received my novak brushless system and was kinda disapointed when i tried to instal it in my t1R, because of the tub and where the battery post lends the motor won't fit, i guess i'll have to use it in my original t1, no big deal but i would've wanted to use it in the T1R.

John Fontaine

iTrader: (2)

You could always modify the chassis to make it fit.

Proto pilot

my mistake... sorry guys... i just tryed seen icehockey mach in same time when i wrote my thougs. My wild thing... i just thinking what size spurgear/pinjon can use if i`ll chance those three pullies to my T1?

Elk666

the chassi looks to be ok, it's just that the battery post is in the way, the BL kit has a tab stiking out at the rear of the motor and that tab gets in the way with the battery post

xwing

I also want the Novak BL for my Evo2, but I dont know where to put the receiver given the big size of the speed controller. Any thoughts?

Elk666

my reciever is shoegooed on top of my servo, no interference/glitching whatsoever, i'm trying the BL motor tonight can't wait

xwing

I see. Let me know the result please.