T.O.P. Racing "Photon" 1/10 EP Touring Car
#4488
#4489
don't over tighten set screws. They strip out of the plastic easily. Where possible, replace set screws with button head screws. They hold up a lot better.
#4490
Tech Fanatic
iTrader: (23)
EJ Evans
Tried your recommended set-up for my foam chassis and med/low roll centers. Did not have the 1.4 sway bar in the rear. The track temp started about 75 then got got down to 65 f. At the end of the day, I have worn a groove on the inside of my tires. I am running the sweep qts-32's. A couple people said I have burnt them up and my set-up is possibly to stiff for the cooler weather. What changes need to be made? Soften the car up? Being new to outdoor aspahlt racing, any help would be greatly appreciated. The track was also treated with sugar water.
Thanks
Everyone please feel free to offer any suggestions.
Tried your recommended set-up for my foam chassis and med/low roll centers. Did not have the 1.4 sway bar in the rear. The track temp started about 75 then got got down to 65 f. At the end of the day, I have worn a groove on the inside of my tires. I am running the sweep qts-32's. A couple people said I have burnt them up and my set-up is possibly to stiff for the cooler weather. What changes need to be made? Soften the car up? Being new to outdoor aspahlt racing, any help would be greatly appreciated. The track was also treated with sugar water.
Thanks
Everyone please feel free to offer any suggestions.
#4492
Can someone tell the difference between these two bones:
PO-SDT008 Universal Bone V2
PO-SDT020 Universal Shaft Set V3
Which do you use for the spool?
And on the diff end, you use the 44.5mm bone, if you are using more then 4 cone washers. Correct?
PO-SDT008 Universal Bone V2
PO-SDT020 Universal Shaft Set V3
Which do you use for the spool?
And on the diff end, you use the 44.5mm bone, if you are using more then 4 cone washers. Correct?
#4496
I have run or should I say I tried to run the aluminum ones with a spool. They do no hold up to the abuse the spool gives. After run number 4 one snapped off. Of course it happened in the main. I was able to drive the rest of the race but the car was not handling very well.
#4497
#4498
ok im going to ask a stupid generic question, but how does this car compare to say an xray?
I had an xray 009 and found it very very good and needed nothing in the 6months of owning it. It steered excellent, yet had heaps of traction at the same time.
is the photon a reliable car? does it need any aftermarket parts?
I had an xray 009 and found it very very good and needed nothing in the 6months of owning it. It steered excellent, yet had heaps of traction at the same time.
is the photon a reliable car? does it need any aftermarket parts?
#4499
ok im going to ask a stupid generic question, but how does this car compare to say an xray?
I had an xray 009 and found it very very good and needed nothing in the 6months of owning it. It steered excellent, yet had heaps of traction at the same time.
is the photon a reliable car? does it need any aftermarket parts?
I had an xray 009 and found it very very good and needed nothing in the 6months of owning it. It steered excellent, yet had heaps of traction at the same time.
is the photon a reliable car? does it need any aftermarket parts?