LRP Vector x12 Brushless Motors
#361
Tech Regular
Hello!
I have one question, is the Octa-Wind version faster then standart? What is the difference in running??
Tnanks!
I have one question, is the Octa-Wind version faster then standart? What is the difference in running??
Tnanks!
#362
Tech Initiate
internal stack wind
Has anyone seen this, i pulled my motor apart to check the bearings and when the case came off the stack and i pulled out the rotor there were two inner winds stuck to the rotor. The motor had run well lastnight with no issues other than a slight hesitation going from reverse to fwd drive and after a crash. please advise.
#363
you should disable reverse to start with
#364
Tech Rookie
#365
WorksTeam Rotors
Hey All
Just wondering I run a Associated 12R5.1 LRP SXX TC Spec V1(1 5 0 2) X12 Octa Wind motor IP 5600mah 50c lipo
I`ve been trying to find some information on these worksteam rotors.My motor currently has the standard 12.5mm rotor.I`ve been looking into buying one of the 12mm worksteam rotors(LRP50636)wondering if there would be much difference in performence.I know they say the 12mm rotor will increase RPM and reduce Torque.
I`ve proberly left information out
Cheers Dan
Just wondering I run a Associated 12R5.1 LRP SXX TC Spec V1(1 5 0 2) X12 Octa Wind motor IP 5600mah 50c lipo
I`ve been trying to find some information on these worksteam rotors.My motor currently has the standard 12.5mm rotor.I`ve been looking into buying one of the 12mm worksteam rotors(LRP50636)wondering if there would be much difference in performence.I know they say the 12mm rotor will increase RPM and reduce Torque.
I`ve proberly left information out
Cheers Dan
#366
Tech Adept
Used this motor for 3 days in a SC truck, and blew up the rotor. The magnets popped out from the shaft
anyway, anyone tried worksteam rotor? how's the different?
anyway, anyone tried worksteam rotor? how's the different?
Last edited by Wilson Picaldy; 01-10-2011 at 07:14 PM.
#367
the octa wind definitely runs a lot cooler than the original version... my first one burnt then switched to octa wind a while back and have not had any issues
#368
Tech Master
iTrader: (22)
Buritos post on the new speedo(in the sxxss thread). Looks like the x12 motors and the SXXSSV2 will be the hot ticket.
http://www.rctech.net/forum/8468822-post1186.html
http://www.rctech.net/forum/8468822-post1186.html
#369
Hello, what is thegearing for lrp x12 13.5 ?
I once had 6 fdr on a medium track, but in the end, the motor was quite cold ... but the weather temp was 1 degree celcius tho ...
I once had 6 fdr on a medium track, but in the end, the motor was quite cold ... but the weather temp was 1 degree celcius tho ...
#371
timing mark question
when using the 4 dot in the x-10 degree position, is it actually -10degrees from 0?
#373
#374
Raced the car today, and compared to the others running 13.5, they were much faster, so i just want to know, whats a good fdr for indoor or outdoor .