Perhaps I should have prefaced my comment that the car on asphalt using a spool handled like a dream. It is only going to the carpet that I have the traction roll problem.

What is the most common kfactory set of springs used with the E4RS???
I have used the factory ones in one race and thought that how could it get better??? I bought a spring set at our lhs and found out that they are for the G4 later on, they work just hope that they are not too stiff.
Thanks alot!

I mainly use the 21-30 K4902 but also have the 31-40 K4903

Wease,
Is this for running primarily on asphalt, I may also run on carpet with rubber tires.
Thanks

I have only ran the car on carpet . I have raced both foam and rubber using the 21-30

Thanks, that is what I was looking for!

No problem

Anyone have a good carpet rubber tire setup???
Will be running Jaco blues or greens
Thanks

anyone know the front toe settings when the inserts are <> and opposite. im using the stock front mount.

There is one at http://www.wolfhobbies.com/ I do believe its in the E4RS downloads

Its 1.5 with the arrow pointing in and 2.5 with the arrow pointing out

That's the one I downloaded which is missing a lot of settings for the 13.5 and the 4.5 isn't too much more helpful. You might as well set your own with all the info that's not there.

I race with Dave quite often so hear is what is missing
#3 hole Fr shock tower
2mm spacer inner camber link
Droop 1 to 2mm over ride height


Rear

#4 hole shock tower
#2 hole on the arm
#2 hole on the rear hub
no spacers inner camber link
droop 1 to 2mm over ride height


Hope this helps.

Mike Pease

whats more toe out on the front arms do to the handling characteristics. where do most people run 1.5 or 2.5. all my other cars corally and tamiya i always ran them straighta at 0.

If my memory serves me right it gives you more entry to mid corner steering . I haven't tried it at 2.5 yet . I will try it next time I'm at the track and let you know.