Steve Weiss

well, there is still time left between now and vegas for places to get restocked

RC MARKET

iTrader: (12)

New design upper deck !

RC MARKET

iTrader: (12)

Fit Xray T2'008 6 Cell

Chris08527

iTrader: (16)

does anyone know the size of the bearings for the alum. rear hub for the 007??? it is a different bearing not the same that goes in the plastic hubs

kn7671

iTrader: (16)

Bearings are the same, all of them, from the '007 and '008. The wheel bearing size is 5x10x4mm.

turd ferguson

iTrader: (3)

The bearing for the aluminum hubs are: 5x9x3
Part number: # 940509

kn7671

iTrader: (16)

Right, sorry, I failed to read the Alum part, but I use Team Tamale Rear hubs which use standard 5x10x4 bearings instead of the 5x9x3 for the Xray hubs.

Chris08527

iTrader: (16)

thanks turd
cuffs says sup, how is the stratus, did you sell it yet???
can you post a pic of it?

turd ferguson

iTrader: (3)

Still have it. Broke a strut the other day (defective part) and that popped one of the air bags for the suspension. Fixing that now and selling it asap. I'll get a pic up in the next day or two. I'll make you a good deal

Cuffs is a good man...

tantalus007

iTrader: (17)

hello there, has anybody here tried fitting a smc 5000 lipo battery on their 008??? will it fit without putting any shims on the bulkeads??? thanks in advance...

RBLove

iTrader: (90)

It will not fit under the top deck. Most people are running it parallel with the rear bulkheads. So the pack actually hangs over the side of the chassis a bit. The 4000 will fit under the deck.

mark34

iTrader: (1)

If you guys feel the need for a 5000mah cap lipo that will fit under the topdeck on the 008 try going to www.demonpowerproducts.co.uk as he has stock of his own batt that will fit.

eded1

Hi, Steve.

What is your next race, is it in europe.
Question:What is the main difference between NOVAK brushless engines
and engines from other firms.
And how many turns Novak is your favorit

Regards , Ed IJzerman , the Netherlands
Xray t'2008

teammidget lilB

iTrader: (19)

It wont fit but I still run it because I have tested many different lipos and feel this one by far has the most power. So I hang it off the chassis and add the lead to balance it to the inside and have had good luck with that!

EAMotorsports

iTrader: (79)

You can also add 1.5mm shims to the top of the bulk head and it will not affect performance. I used the silver shims that come with the kit for the Hinge pin mounts. The front ones will have to have one side flattened out a bit so the dont hit the shock tower mounts. The rears are just big enough that they catch the layshaft mounts perfect. Then the lipo will fit perfect.

For foam tires this may not work as it may or may not add extra flex. just from bench testing and feeling the chassis with and without spacers I can not tell a difference. Cant tell a difference on the track either. Rubber tire asphalt.

EA