BMI's DB12R
#6796
Moderator
iTrader: (9)
Join Date: Jan 2004
Location: Outside doing things in places... Denver, CO
Posts: 4,609
Trader Rating: 9 (100%+)
I'll be testing out Jasons setup above only with a flat servo, and the stock flex plates in the long position without screws. I have thin plates on their way but not sure if they will be here before Sunday. I have the LiPo and booster all installed and ready to go.
I am also going to be testing some differnet foams for tires. I may try the Lilac and Yellow I was running for 4 cell at first. I have some CRC Grey-Lo's I want to try on the rear.
I am also going to be testing some differnet foams for tires. I may try the Lilac and Yellow I was running for 4 cell at first. I have some CRC Grey-Lo's I want to try on the rear.
#6797
Tech Champion
Here's an interesting body I found on ebay. Mounts a bit higher then I want due to the pod but still looks great I think
#6799
Tech Champion
I don't think so...it is some guy who molds em at home.
Send em over!
Send em over!
#6801
Hey Inspector I bought two of those bodies also, it has a cool cam-am look to it, just need to paint them up now. Have'nt tried to fit it on the car yet, you say its a tight fit over the top of the rear pod?
Chris
Chris
#6802
Im pretty Josh made a body that looked very similar to that body.
#6805
Now why don't I see those at the OCS races??
Nice body there...
Nice body there...
#6806
Tech Champion
Yeah just a bit. The bottom cut will need to be almost where the mold flattens out.
#6807
Tech Champion
Similar but not the same. The CEFX body I see on the site has the rear wing molded on...this one is bolted on. Also you'll notice on the CEFX also has vents over the front wheels where this one does not. There are some similarities but I imagine if you put them side by side they would look totally different.
#6808
Tech Champion
#6809
Tech Champion
#6810