TLR TEN-SCTE 2.0 Kit Thread
#3797
Tech Champion
iTrader: (168)
Part numbers are 67169 for Futaba, 67167 for airtronics. not sure for Hitec.
They only have one hole and are kind of long so I drilled and tapped a new hole to match the length of the stock servo horn. My servo horn can be seen at the right edge of this pic of my 5th body post mount:
#3798
R/C Tech Elite Member
iTrader: (198)
Hummmm
That's nice.... but I have R10 Pro's
Too bad you don't have a second RX8, they are shipping gen 2's just so you know, haha. In regards to the R10, it needs to be the R10 Pro for starters. Then if you do not have their box to load the 4 pole software which is the best thing to do and in that case you would run the sensor wire, you would run without with the 2 pole software so it doesn't error into sensorless, it just runs that way naturally. Then you will have full power at least.
Who Uses the Orion R10/4600 Tekin combo, are there any problems stressing that combo? Are you using sensor wire? I heard you need to run without sensor wire. Or is that some wrong info...
I use the RX8 now and want to move it to my 1/8 scale and drop the R10 in the 2.0
So who has this setup and how's the Temps and Power??
I know to program it I unplug the motor..... but my buddy says he cant run it in Sensor Mode.
I use the RX8 now and want to move it to my 1/8 scale and drop the R10 in the 2.0
So who has this setup and how's the Temps and Power??
I know to program it I unplug the motor..... but my buddy says he cant run it in Sensor Mode.
#3804
Yes my outdrives move around a lot. They are not leaking and nothing is broke but it sure does feel like the there is something wrong.
#3806
Just a little psyched for the weekend -
#3808
Hello all, are their anyone running the STRC Bell Crank in the Losi ten 2.0? If so how do you like it and does it take the slop of the front end?