R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Electric Off-Road (https://www.rctech.net/forum/electric-off-road-4/)
-   -   SC10 4x4 Thread (https://www.rctech.net/forum/electric-off-road/511493-sc10-4x4-thread.html)

Evil Genius jr. 12-30-2011 09:36 AM

Ok, I will when I decide what to do (stay stock or go saddle).
Thanks!

MantisWorx 12-30-2011 09:42 AM


Originally Posted by Evil Genius jr. (Post 10100172)
Ok, I will when I decide what to do (stay stock or go saddle).
Thanks!

inline saddle is the way to go........

CraigMBA 12-30-2011 09:42 AM


Originally Posted by derbrylac (Post 10100136)
and lastly if it still steers around way too much over drive the front using the 19t pulley. hope this helps a little.

D

I disagree with this part. Over driving the front end will make the truck turn more center off, or at least when you get back on the power.

Evil Genius jr. 12-30-2011 09:46 AM


Originally Posted by MantisWorx (Post 10100196)
inline saddle is the way to go........

I know that it's just I already have a couple of stick packs and no saddle packs so...

R Doyel 12-30-2011 09:48 AM

Thanks for the tips. I just checked the ride height, and it was super low in the rear......tons of scrapes on the back of the chassis. I leveled it out, I'll see if this does it....:)

derbrylac 12-30-2011 09:50 AM


Originally Posted by CraigMBA (Post 10100197)
I disagree with this part. Over driving the front end will make the truck turn more center off, or at least when you get back on the power.

I had the exact opposite. mine was steering in alot and overdrives the front in made it push more and took away some of the steering on power. off power it still had lots of steering. so I up'd my front diff to take away more steering I guess each driver have different setups. this is just from my experience.

Chad Smith 12-30-2011 09:52 AM


Originally Posted by Evil Genius jr. (Post 10100209)
I know that it's just I already have a couple of stick packs and no saddle packs so...

I am in the same boat, but saddles are not that expensive. You can buy some saddles for 30 bucks.

derbrylac 12-30-2011 09:55 AM


Originally Posted by R Doyel (Post 10100221)
Thanks for the tips. I just checked the ride height, and it was super low in the rear......tons of scrapes on the back of the chassis. I leveled it out, I'll see if this does it....:)

testing this out from a known company and put over 20 batts and still going strong.
http://i915.photobucket.com/albums/a...c/f37a7a2c.jpg

thebizz 12-30-2011 10:13 AM


Originally Posted by mccune211 (Post 10100149)
Just had the front diff on my rtr bind up one wheel spun the other didn't I turned little by hand now works fine anyone else have this prob or any idea y it did this

You might of chewed up the idle gear . take it apart and check it.

thebizz 12-30-2011 10:16 AM


Originally Posted by MantisWorx (Post 10100196)
inline saddle is the way to go........

Marcus do run the b44 mount with the exotek chassis or the stock chassis

Steve737 12-30-2011 10:48 AM

Alright, got my motor/esc choices down to two. Either the Castle Creastions 1415 or the Novak Ballistic. Recommendations between the two? Thanks.

jimmer411 12-30-2011 10:56 AM

Anything but Novak :nod:

vito 12-30-2011 11:09 AM

iam going with the new reedy 550 one

Chad Smith 12-30-2011 11:32 AM


Originally Posted by Steve737 (Post 10100471)
Alright, got my motor/esc choices down to two. Either the Castle Creastions 1415 or the Novak Ballistic. Recommendations between the two? Thanks.

Most people run tekin why dont you want a tekin? The 1415 I would not suggest for this truck. That motor is designed for 3s and over lipos. It was designed for bashing. I am not saying that it will not work but not as well compared to a smaller can motor. With the 1415 being that big you are limited on gearing as well. With the stock spur I could only run up to a 19 thooth pinion. But coyoteslash runs that motor and a smaller spur so that he can run a bigger pinion to get the power that you need. Is there a reason you voted out tekin?

Mizchief 12-30-2011 11:37 AM


Originally Posted by Steve737 (Post 10100471)
Alright, got my motor/esc choices down to two. Either the Castle Creastions 1415 or the Novak Ballistic. Recommendations between the two? Thanks.

I really liked the ballistic 550 combo, but either the esc or motor crapped out on me and got the "kick start" syndrome. So I swapped it for a mmp & tekin pro 4.


All times are GMT -7. It is currently 07:01 AM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.