Nope, I mostly run indoor high traction clay all the time, the outdoor track is a rare event for me so never bothered to try the overdrive.

When I used 60 g it was too much and since I run outdoor/ indoor with much bigger jumps the weight ended up falling off.

Wildcat im in blinky mode

I used 3m outdoor mounting tape (5 lbs version). I put some along the side wall of the chassis and put the lead in. This helps to keep it in by having the lead stuck to 2 surfaces and no glue is required.

lower the cutoff but not more than .2. You want to have some buffer for the current that 4 pole will pull. Motor temps should be 160 or below. If you are blinky then you probably need to play with your gearing. you could drop to 11 and try 12,13,14,15 and check temps. Then use the pinion that gives you under 160 degrees.

http://thumbp6-ne1.thumb.mail.yahoo....1256&fid=Inbox

http://thumbp6-ne1.thumb.mail.yahoo....1256&fid=Inbox

http://thumbp6-ne1.thumb.mail.yahoo....1256&fid=Inbox

added the weight yesterday and it helped out a lot! truck is more planted

added it where

all the brass weight.. 40grams next to the saddle packs and 40grams by the servo

are you running the exotek chassis also?

no.. the picture above shows the plastic chassis

The pictures dont show for me.

how do i show you? i tried to post a picture.. it showed for me but not for you?

Thought you were referring to Scotty's Show
Down race hosted this spring .

Had like 250+ at our own Sc National here in WA , no Ryan's either .

When I got the email saying you posted on this threat, I saw there were 3 links to yahoo. But none of them worked for me and they dont display here. You can use the upload feature on rctech. If you have the pictures locally.Create a post and click on the attachment icon.

I chose to install two Reedy 4000mAH Shorty packs in my SC10 4x4 to add weight to the front. I don't have the Exotec chassis so I needed the 80gms like Maifield did. Two shorty packs are about 100gms heavier than the saddle packs so I figure that I am getting almost the same weight even though it is positioned a little to the rear. I removed all other added weights.

Mounting:
I used the Factory Team upgrade kit mounting parts to create a new mount. I had to cut the post side down and drill two holes to attach it on the right side back in front of my speedo. I then cut down the stock stick pack brace and created a circular cut to fit under the post. Then I use the stock locking mechanizm. It seems to work really good. I had to add additional foam to the left side and added the pad underneath.

Wiring:
I soldered two leads to a 4mm female bullet connector so that the male from my speed connects up nice. One y cable for the positive and one for the negative and I am in business. 8000mAH with not much added weight...weight I needed to add anyway.

I will weigh each corner and take some pics to show what I did soon. I hope to get 50/50 weight eavenly distributed side-to-side.