Losi 1/10 TEN-SCTE ARR 4x4 Short Course Truck Thread
http://www.horizonhobby.com/Products...FVAaQgodIwM58g
Do you mean put the O-Ring on the BOTTOM of the fan??? This is one of the fans/heatsinks i have.
http://www.horizonhobby.com/Products...FVAaQgodIwM58g
http://www.horizonhobby.com/Products...FVAaQgodIwM58g
Sorry should have mentioned this tip was for the tekin rx8.
Do you mean put the O-Ring on the BOTTOM of the fan??? This is one of the fans/heatsinks i have.
http://www.horizonhobby.com/Products...FVAaQgodIwM58g
http://www.horizonhobby.com/Products...FVAaQgodIwM58g
Have a question, waiting on my seconds Losi to get here, and I received the replacement gears and pins from Horizon about a month ago from my first Losi that I had. Anyway how can I tell if the gear set contains the updated pins?
Does anyone know?
Does anyone know?
any one running the T bone back bumper ? I have mine on my truck and its kinda sticking out there almost two inches past the back of the truck.. is this right ? or did I get the wrong part.. its etched on the part ten losi ?? either the flo tek or the stock body is the same. I am thinking about putting the stock 3rd replacement bumper back on after the next race .. Thanks
Tech Regular
iTrader: (5)
FAN issue
Cut the ends of the blades off a 1/4 inch.. Gets rid of the Flex and they last forever.. I went through 5 fans before Randy Pike at Tekin told me how to do it ... Hope this helps save you some $
Cut the ends of the blades off a 1/4 inch.. Gets rid of the Flex and they last forever.. I went through 5 fans before Randy Pike at Tekin told me how to do it ... Hope this helps save you some $
Thanks buddy! lol. I led the first 5 1/2-6 minutes of that A until I made a couple mistakes clipping pipe, and thats all it takes, Dumper doesnt make mistakes very often.
Tech Master
iTrader: (9)
It would be helpful if all the RCShox info could be kept in that thread. According to what I have read your on the right track with the lighter oil to start. If the chassis slaps then go up on oil. On a bigger outdoor track we started with 30 and Bill is running 35 now. I will be doing more testing when I get my Novak back. It probably won't be in time for your race though. Good luck.
Tech Elite
iTrader: (86)
any one running the T bone back bumper ? I have mine on my truck and its kinda sticking out there almost two inches past the back of the truck.. is this right ? or did I get the wrong part.. its etched on the part ten losi ?? either the flo tek or the stock body is the same. I am thinking about putting the stock 3rd replacement bumper back on after the next race .. Thanks
Tech Prophet
iTrader: (34)
There is a 3rd generation rear bumper that fixes most of the breaking of the rear bumper. Not saying you can't break it as I have faith some of you guys can break anything But it is much stronger in the places it was breaking before.