Can somebody put up a list of all the sizes required for allan head screws and hex heads and any other tools required for assembly and maintenance on the b44.1. Or are there any recommendations on sets best suited for this kit. I want to price some individual drives vs sets to see which is most economical way to set up all the tools required.

http://www.teamassociated.com/parts/details/1655/

You will also need a set of nut drivers, any will do.

http://www.amainhobbies.com/index.ph...s-Standard-SAE

That's great but you don't need half those sizes do you ?
Please correct me if this is wrong, These are the only sizes required for the B44.1
Hex drives: .05", 1/16", 3/32", 5/64"
Nut drives: 3/16", 11/32", 1/4"

Damn still no losi bb conversion parts in

Those springs made my 2wd feel like it was a moving pillow on the track.

Agree..

The track I race at has a whoop section that can make or break ya through it.
My 2wd's fly through it. the b44.1 not so much

installed the front silver BB springs... made it so much better. lol it can make it through them now.

Help what do you guys mean by Silver BB springs?

Brent- look what you started!!!

oh snap

hehe

the Losi 22 BB 12mm springs will fit our buggies. B4.1 front/rear, B44.1 front/rear and SC10 2wd Rear so far. I haven't finished finding the parts for the front

You can run them and really fine tune the spring rate and they look SWEET
also help with the spring not hitting the shock shaft in the rear.

I like the feel of them...

I can get some pics if you want them

B44.1 Front with BB silver springs


SC10 2wd rear. crappy pic sorry


B44.1 front shock-crappy pic again sorry

Are most guys running yellow Losi BB springs for the rear on the 44 too?

I did on my b4.1 and hated it.
the Yellow BB springs are 2.00 lb the factory AR green are 1.90 lbs.

My buggy pushed to much with the yellow on. I ended up installing the Pink..

What kind of surface do you run on?

Clay/dirt mix. some what bumpy and is always damp now

Please correct me if this is wrong, These are the only sizes required for the B44.1
Hex drives: .05", 1/16", 3/32", 5/64"
Nut drives: 3/16", 11/32", 1/4"