grapejuice

iTrader: (153)

That's whats in mine

tonyv2382

iTrader: (67)

I run on a seriously rough track and never had this popping off issue. Only issue Im having is the front susp holder keeps breaking and the aluminum ones are out of stock everywhere

Slim18

I'm thinking about picking the dex410r up sometime in the near future. what what steering servos are recommended for this kit.
any help would be greatly appreciated

Dlewis4

iTrader: (148)

Most likely anything high torque high speed.


So, if i am to order a new kit, what shuld i also order to keep for spares, as no one around here keeps parts for them at the time being,.

tonyv2382

iTrader: (67)

If you get the R get like 10 hinge pin holder sets...the front one will break on you million of times for no reason lol. And the aluminum holders are out of stock everywhere Ive checked every site. Im banking on this guy from the UK to send me it. Other than that I think you'll be fine. this kit is tough.

t0p_sh0tta

iTrader: (35)

They're in stock at TD. Don't forget that you'll need the pivot balls as well for the alloy blocks.

I'll be ordering from TD this week.

tonyv2382

iTrader: (67)

ya but its like 30 usd to ship man im not paying that. I have the pivot balls but I have a question...If I just use the front holder all I need to do is add the pivot balls up front right?

t0p_sh0tta

iTrader: (35)

And a few shims. Check out the 410 instructions.

I'll be placing a an order any you're welcome to add to it to save on shipping.

If you're looking for more vouches, check out my feedback on eBay.

Dlewis4

iTrader: (148)

So, front arm mounts, and....a different ballcup/joint setup?

And then when I can... get the aluminum ones...

mdowney

iTrader: (21)

What's "TD"?

tonyv2382

iTrader: (67)

a sexually transmitted disease lol

mdowney

iTrader: (21)

No kidding. My front left hinge pin popped out the very first time I put her on the track. The holder didn't break though.

Unfortunate design flaw...

t0p_sh0tta

iTrader: (35)

Team-Durango.com

mdowney

iTrader: (21)

Oh, duh...

tonyv2382

iTrader: (67)

LoL...Funny. Well look if we all get in on this mass order we can beat the shipping costs as theyre too expensive. I got this guy in the UK who might send the part to me but Im waiting for a response. But if we get coorinated here we'll be ok.