R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: BCDK
Showing results 1 to 25 of 99
Search took 0.01 seconds.
08-18-2016, 03:49 AM
Replies: 290
Views: 60,998
Posted By BCDK

Yes

Yes
06-10-2016, 04:02 AM
Replies: 1,005
Views: 284,344
Posted By BCDK

Already in January at the DHI Cup in Denmark I...

Already in January at the DHI Cup in Denmark I had the prototype in my hands and played around with the suspension at the pit table. Very innovative design. Yes - some small parts in the suspension,...
05-27-2016, 06:58 AM
Replies: 104
Views: 29,329
Posted By BCDK

Release in June - but shipment in July is the...

Release in June - but shipment in July is the last I've heard.
05-18-2016, 03:36 AM
Replies: 11
Views: 2,154
Posted By BCDK

You will probably get as many answers as there...

You will probably get as many answers as there are battery brands...!!

My best answer to you is: go to your club, ask your club members and bye what they prefer. There are no big differences...
05-10-2016, 04:03 AM
Replies: 290
Views: 60,998
Posted By BCDK

I would also check the diff. oil. Go a tick...

I would also check the diff. oil. Go a tick lighter oil.
02-10-2016, 03:59 AM
Replies: 290
Views: 60,998
Posted By BCDK

Not just the reason, why we choose the Serpent. ...

Not just the reason, why we choose the Serpent. :)

... and also a Serpent S411 4.0 can brake. :(

We were at a race, where we had a chrash. Hit the curb on the inside into the straight - in...
02-03-2016, 07:48 AM
Replies: 852
Views: 159,694
Posted By BCDK

Man - you use very thick oil - 1200 wt :) I...

Man - you use very thick oil - 1200 wt :) I think you have 1200 cst.

The silicone seal is durable. I often open my diffs, and I never had a problem with the seal. In fact I never had a leak. I...
02-03-2016, 04:07 AM
Replies: 852
Views: 159,694
Posted By BCDK

One thing you can check, if you have a V3 or V4...

One thing you can check, if you have a V3 or V4 diff:
- The diff half, where the oil is: the bearing is very tight on the V3 diff and you have to push the bearing hard to fit it correctly.
- On...
01-27-2016, 04:28 AM
Replies: 290
Views: 60,998
Posted By BCDK

Inside upper link: if you add shims here you...

Inside upper link: if you add shims here you lower the roll center. Shims on the upper inside link is about 1/4 or 1/3 of the low rc adjustment = shims under the blocks.

That is the way I do it,...
01-26-2016, 04:24 AM
Replies: 290
Views: 60,998
Posted By BCDK

Both my sons are driving the 4.0 - one in...

Both my sons are driving the 4.0 - one in modified and one in superstock (13,5 T blinky) - and they don't use the same diff-setup. In modified startingpoint is 5k and in superstock 3k.

It depends...
01-15-2016, 05:44 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

:) Nice to see this article used. I wrote it for...

:) Nice to see this article used. I wrote it for my son Rasmus, when I was the mechanic on his cars.

Another good idea maybe a to buy: all the wishbone blocks are made of plastic, and they have...
01-05-2016, 04:15 AM
Replies: 852
Views: 159,694
Posted By BCDK

We have had one test day with the new 4.0 too -...

We have had one test day with the new 4.0 too - but with the alu chassis. It works great. Dampers are the biggest improvement, but also the play free steering have to be mentioned as well as the new...
02-16-2015, 08:21 AM
Replies: 852
Views: 159,694
Posted By BCDK

Hi. Just tried the Dart yesterday for the...

Hi.

Just tried the Dart yesterday for the first time on a high speed track with mid grip. The Dart was way better than the Mazdaspeed6. More steering and easier to drive - especially to drive...
07-24-2013, 01:37 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Hi. You can use one of these: Tamiya...

Hi.

You can use one of these:

Tamiya blue = 272 gf/mm - 27 mm
Ride MR33 green = 272 gf/mm - 25 mm
HPI blue = 273 gf/mm - 26 mm

The Tamiya spring is a bit too long, so you might get...
07-24-2013, 01:25 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Hi. Manny drivers are doing this now. Most...

Hi.

Manny drivers are doing this now. Most of them use a slice of lexan - fx from the edge of a new body, which you cut of and throw away. Some have a carbonlike tape, they put on to get it look...
04-23-2013, 08:16 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Rear front R/F makes sence. It will stiffen the...

Rear front R/F makes sence. It will stiffen the rear and give you more steering. The rear can have to much grip. We tried the same with good result - especially on high grip tracks.
02-18-2013, 01:08 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Hi. I think, you have tighten the set up...

Hi.

I think, you have tighten the set up screw in the arm too much or you have tighten the shock mount too much.

If you tighten those two too much, you can easaly pull the set up screw out of...
02-15-2013, 12:18 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Marc is sponsored from Sanwa. I know he also has...

Marc is sponsored from Sanwa. I know he also has a M12, but his orange painted transmitter is a M11X.
02-13-2013, 11:34 PM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

His transmitter is not wrapped - it is painted...

His transmitter is not wrapped - it is painted orange. He has separated the transmitter - painted the black plastic - and put it all together again. I think he has used car paint.
02-11-2013, 12:47 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Hi. We let an extreme good driver try our...

Hi.

We let an extreme good driver try our new Eryx. Normally he drives a BD7, but he don't like it. It is difficult to drive and find a setup for. His words. Therefore, at the last race he drove a...
02-08-2013, 07:31 AM
Replies: 10
Views: 5,356
Posted By BCDK

It will fit - as every other 2s lipo.

It will fit - as every other 2s lipo.
02-08-2013, 05:55 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

To be honest, I don't know. I know from Marc,...

To be honest, I don't know. I know from Marc, that he has two different cars; one with 2,25 mm chassis and the second with 2,0 mm. In practices he drives both cars and chooses the best reacting car...
02-07-2013, 11:43 PM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

For your info: the 2,0 mm chassis is stiffer than...

For your info: the 2,0 mm chassis is stiffer than the standard 2,25 mm chassis. It comes, because the carbon is wowen square and not lenghten. It has another flex. I have it from Marc F.
02-04-2013, 08:37 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

We also got the new Eryx. Wonderfull car. Really...

We also got the new Eryx. Wonderfull car. Really nice to built. I had a little play at the diff, but a .2 mm shim did it. And also at the spur axel I had a play. Again - .3 mm shims did it. Later I...
02-04-2013, 08:24 AM
Replies: 6,996
Views: 1,110,940
Posted By BCDK

Hi. You need to complete rebuilt the djc...

Hi.

You need to complete rebuilt the djc axles some times. Maintenance: check often (at least every week), if there still are some grease behind the shrink foil. If not, put some black grease in....
Showing results 1 to 25 of 99
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.