20LikesTeam Associated TC6 Thread
10-02-2012, 10:17 AM
#7501
I will try the 4mm hexes nevertheless because my TC6s can never have enough grip. I can even run them narrow on high grip carpet with CPX tires without rolling it.
10-02-2012, 05:25 PM
#7507
They are not intended to give longer links, just the vertical ballstud tuning option. V1 is the same length as #s 1/3 on the tower, and V3 is the same as #7. V2 is in between. 2.5mm w/ a short bs is the same height as the #1 hole. Start with what you have been running, and tune from there.
Yes, they do. 5mm hex is the same as the standard hex.
Yes, they do. 5mm hex is the same as the standard hex.
10-02-2012, 06:11 PM
#7508
but studs have been around for a while now
31372 and 31373 for cap A and Cap B,
31374 and 31374 for long and short neck 3.25 ballstuds
31376 and 31377 for new F and R shock towers,
New shock towers are not needed existing ones can be cut down on a bench grinder rather neatly. I had spares so i did this and you cannot tell the difference.
Beth.
10-02-2012, 06:27 PM
#7509
So will there be Worlds update kit? I haven't even finished building my 6.1 .
10-02-2012, 06:48 PM
#7510
WC Chassis
WC chassis is SUUUUUPER narrow at 80mm
10-02-2012, 07:26 PM
#7513
Vertical Ballstud Bearing Caps
Hey Guys,
I used to run #3 front and rear as my camber link position. Whats the equalivent on the the Vertical Ballstud Bearing Caps and what size shims do I use? Still confused...
I used to run #3 front and rear as my camber link position. Whats the equalivent on the the Vertical Ballstud Bearing Caps and what size shims do I use? Still confused...