Awesomatix EP Touring Car (A700 Shaft Drive)
#3346
#3347
.
#3348
Well, i've joined the awesomatix club! Can't wait to get my kit back from anodizing and start building. Thanks again Hanulec!
#3350
#3351
Blacked out
I think we have a one inch length on top and half inch on the sides so you may not qualify.!!!!!
#3352
#3354
Tech Addict
I ran my Awesomatix tonight at Lou's Speedway near London Ontario Canada. I'm impressed. I just finished the car 1 minute before the first qualifier and was on pace to beat my best time that I ran with my Xray T4. I had first run tires and zero runs on the car, yet set TQ for STOCK TC for the night. I can't wait until next week.
#3355
R/C Tech Elite Member
iTrader: (28)
I ran my Awesomatix tonight at Lou's Speedway near London Ontario Canada. I'm impressed. I just finished the car 1 minute before the first qualifier and was on pace to beat my best time that I ran with my Xray T4. I had first run tires and zero runs on the car, yet set TQ for STOCK TC for the night. I can't wait until next week.
#3356
R/C Tech Elite Member
iTrader: (28)
Just posted - Aaron Young's Asphalt NorCal Hobbies Setup
http://racerlog.com/wiki/Awesomatix_A700#Setups
http://www.awesomatixusa.com/p/setup-sheets.html
note - the setup sheet has been updated. one or two measurements where left off.
http://racerlog.com/wiki/Awesomatix_A700#Setups
http://www.awesomatixusa.com/p/setup-sheets.html
note - the setup sheet has been updated. one or two measurements where left off.
Last edited by hanulec; 04-19-2013 at 04:35 PM. Reason: pdf update..
#3357
What kind of grease is everyone using on the drivetrain gears?
#3358
Tech Adept
I'm using Anti Wear Grease from 3Racing and it works quite good.
#3359
What is the difference between the 3 models of Awesomatix kits?
#3360