Team Associated TC4
Tech Elite
iTrader: (84)
Thanks, I cut it on my mill with a carbide endmill. And i used a 3/8 spot drill 90deg.
Tech Champion
iTrader: (31)
Tech Elite
iTrader: (84)
Tech Champion
iTrader: (2)
This thread makes 90% no sense....
Good humor all the same....lol...
Good humor all the same....lol...
Tech Champion
iTrader: (31)
Tech Elite
iTrader: (2)
Tech Regular
iTrader: (5)
So I was looking at some chassis shots of the apex and it and the tc4 look fairly similar. Has anybody tried to put the gear duffs from the apex into a tc4? They may be less work than b44 diffs
I hope those Associated bigshots are reading this thread and noting that racers want a GEAR DIFF & DCJ DRIVES for the tc4 club racer !!!!!!!!!WAKE UP!!!!!
Tech Master
iTrader: (10)
I think I saw the same thing and was wondering that myself. It would be nice if it does.
Tech Champion
iTrader: (31)
For those of you that plan on using the B44.3 gear diff's once they have been tested out your going to need different outdrives ( TC6 part #31346 ) since the B44.3 ones are to long by about 3~3.5mm...
More testing to follow and pictures once the machining is completed
More testing to follow and pictures once the machining is completed
Tech Elite
iTrader: (84)
Tech Regular
iTrader: (5)
I'm guessing they would tell u that b44.3 diffs wont work also
Tech Champion
iTrader: (31)