HOBBYWING TECH SUPPORT 1/8 & 1/10 OFF ROAD
#1531
Tech Elite
iTrader: (103)
The case is held on with two screws (jewelers phillips) on the bottom, two snap tabs on the side underneath the stickers. I just peeled up the stickers and "unlocked" the tabs. Then it should open up. Take your time peeling up the 1s heat sink off the mosfets so you don't damage the heat transfer tape. Then put the heat sink in the top half with the tape between the heatsink and mosfets and close it up.
#1532
Tech Elite
iTrader: (103)
I'm running a 7.5 on a small to medium sized track. Stock spur with a 20T pinion. Punch at level 3 is really smooth. I'm also running just a small amount of boost timing (function 9) set to value 2 ( 3 degrees ) with no turbo and the car is a ROCKET! I think a lower punch value really helps to make the traction controllable outta the turns which really makes it accelerate hard.
#1533
Xerun 150a running the most recent firmware I can find and the temp protection drop down is grayed out on the USB link software... And there is no option for it on the LCD programmer. maybe... I need to check this again...
Any insight?
Any insight?
Last edited by BillyT.; 12-31-2012 at 12:04 PM.
#1534
#1535
Tech Rookie
need help with program card
Hi I have a ezrun 3656 4000kv I can't get the program card to work it comes on with straight lines no numbers
#1536
What firmare and software do I use with the SCT pro and HW 3656SD 4700kv?
#1537
ordered from http://www.falconsekido.com/ and there service is great.
I ordered three xerun 150a escs from them in the last couple weeks and their shipping was super fast.
#1541
For you guys running the 120a sct pro and a 4 pole motor, do you notice any difference between punch and timing changes? I've tried multiple settings and I cannot tell (gps verified) any change. Whereas I have a viper esc and it's night/day difference when timing and punch kick in.
#1542
Tech Rookie
Same here! Which is the latest firmware for the ESC and prog.box?
#1544
http://www.falconsekido.com/pages/download
I downloaded the latest software and it says it can't open this type of file....Anyone else get an error message?
#1545
mine downloaded and works fine except for the grayed out temp protection
Last edited by robbieg; 01-04-2013 at 02:58 PM.