26LikesKyosho v-one r4!!!!
10-11-2011 | 10:37 PM
#496
Tech Regular
Joined: Nov 2005
Posts: 498
From: Greece
I ran the new case with the old gears (haven't got the steel gears yet) i shim .1 behind 2 of the four small gears, i tried 4 shims but it was to tight so i tried the 2 and it work fine all weekend we had rain so i was limited to about 20 minutes of track time so i will run again n two weeks and let you know. mine diff leaked but it was deffinely because i over filled it. I will put a little less fluid next time. note my two speed wobles but I have not had any problems with the gears.
Or if you buy new diff case then you shim default (1 up and down)
10-11-2011 | 10:59 PM
#497
No need to shim small gear. Add one more shim to top and bottom big gear, fill full with oil,work a little the diff, let it rest and screw 3 of 4 screws and let a little oils to pop and then screw all of them. You are done with no leak and problem.
Or if you buy new diff case then you shim default (1 up and down)
Or if you buy new diff case then you shim default (1 up and down)
10-11-2011 | 11:42 PM
#498
Tech Regular
Joined: Nov 2005
Posts: 498
From: Greece
10-19-2011 | 11:17 PM
#501
VZW409 effect rear roll center because you can change arms height. But also change the width of rear arms. Car is very fast and every race go faster because of new things we find to make the setup better. The only think i try to find is to make the rear of the car to rotate . Car is understeering and i think that is because of rear too much handling...
10-20-2011 | 02:37 PM
#504
Tech Initiate
Joined: May 2011
Posts: 37
10-21-2011 | 02:04 PM
#505
Ah ok. That makes sense now. Thanks. What is the part number for the offset plastic part as they don't come in the kit for the rear only the front which are too big.
10-21-2011 | 07:16 PM
#506
Tech Initiate
Joined: May 2011
Posts: 37
You must buy VZ410. So you can change also front roll center. The only think you must always see is the width of the car because when you change the lower arm height you also change arm width...
10-26-2011 | 03:51 PM
#509
R4 vs!
I could be wrong, but rightnow I don't think anybody who switched from RRR to R4 is actually going any faster.......atleast the few I've seen at our track!!
10-27-2011 | 03:37 AM
#510
Tech Initiate
Joined: May 2011
Posts: 37
Here is my friend the best ever kyosho R4 race result
The best nitro 1/10 driver in GReece with its mechanic PAnos KIrkos got the pole and the second place in podium
http://www.rc-world.gr/nikites-gas-open-25-sep-2011
Thanks to my sponsors , i" ll keep up with the good results
Nikolaos Nikiforos
The best nitro 1/10 driver in GReece with its mechanic PAnos KIrkos got the pole and the second place in podium
http://www.rc-world.gr/nikites-gas-open-25-sep-2011
Thanks to my sponsors , i" ll keep up with the good results
Nikolaos Nikiforos