Slapmaster Tools MS2.3
11-20-2005 | 01:43 AM
#32
Tech Fanatic
Joined: Jun 2003
Posts: 835
From: South Carolina
Originally Posted by Slapmaster6000
Here's Hyperdrive's website: www.hyperdriveracing.com
Their parts that I use are:
HK-0007 damper tubes
HK-0008 ball studs
HK-0009 2.56 nuts
HK-0003 upper plate
Their parts that I use are:
HK-0007 damper tubes
HK-0008 ball studs
HK-0009 2.56 nuts
HK-0003 upper plate
11-20-2005 | 11:24 AM
#33
Jesse, I think that you will be impressed too. You will be able to build your diff and forget about it. Unless one of your buddies "spur" you, will mostly never have to look at the back of the car this season! I continue to run a diff that was built the start of '04-05 racing season without any maintenance. And its just as smooth.
Thanks for your support.
Thanks for the Hyperdrive sources!
Brian
Thanks for your support.
Thanks for the Hyperdrive sources!
Brian
11-20-2005 | 10:48 PM
#35
Originally Posted by Number 11
Any ideas where I can get HK-0008 ball studs I can't find them at the track or on any of the sites listed. I can't complete the car until I get ball studs.
Go find a hobby shop that carries a big Du-Bro selection, hobby shops that carries airplane stuff usually will have this. Du-Bro part# 181. It's description is "2-56 Threaded ball link", about $1.55 each. Each package includes a 2/56 ball stud that is perfect for out application, some other hardware, also a clear ball end that you can use for the CRC tubes as well!
Try to call around and find it, if not pm me before noon and I can go to the shop that I found these during lunch and check it out. I also have 3 new packages in my 1/12th box. And I know I still have 4 on my car if needed. I can send them up USPS priority mail, should get there in about 2 days.
Dom
11-20-2005 | 10:49 PM
#36
Did Weylin run the 5.5 or 6.5 motor? Are you finding you're having to do anything special to get the GTB/Velociti system to run in 4-cel fettle? Is a receiver pack necessary?
Many thanks,
Scottrik
Many thanks,
Scottrik
11-21-2005 | 07:29 AM
#38
FWIW, the CEFX dampner tubes will also work, and they use 4-40 ball links on both ends of the tubes. If you're partial to using 4-40 ball studs and links like I am, you will appreciated the CEFX tubes.
They are short enough and fit perfectly (actually, the dampner widths on the CEFX are very close to the MS2.3). I'm going to see how well the CEFX pod will match up to the MS, but from my initial measurements, it looks like a perfect fit.
They are short enough and fit perfectly (actually, the dampner widths on the CEFX are very close to the MS2.3). I'm going to see how well the CEFX pod will match up to the MS, but from my initial measurements, it looks like a perfect fit.
11-21-2005 | 07:38 AM
#40
I got my dampner tubes and other CEFX parts from www.stormerhobbies.com. www.kthobbies.com also carries CEFX parts, though everyone's stock appears to be low right now. Josh must be behind. 
