I just ordered the Arrowmax mid motor conversion kit for my Project 4X. Anyone tried this conversion?

I have. Very nice, but I found a default in the conception, the front part of the upper deck is very thin and there is nothing to prevent it from breaking on front crashes. Maybe a X-brace or something would have been nice. But the car is really working well with the mid-motor.

Nice I just like this car I don't see the point on switching to different car. Thanks

Airwave can you post pics of your car.

Would like to but can't... I'm back to rear motor configuration with Arrowspace chassis...

got my medius 4x ready to hit the track.

If you guys haven't noticed I'm using floating steering and servo mount down the center line of the chassis.

May I ask, how is the weight distribution with your set up .....

Regards
BM

The electronic rear end side is very light and I am using LCG lipo.. so right now I am sitting at 1310 grams still waiting for weights to come in to get it up to minimum weight limit.

try these they are awesome and take little space I got mine from ACE hardware but any hobby town should have them

I went to practice today I run my serpent 4x on medius motor layout after a dozen of setup changes holy crap the car is on rails. Never imagine the car will be this good.

Got some 1mm thick brass from my local hobby shop cut to fit under the battery, receiver and ESC. Walla car was perfectly balance left and right.

What's the diameter of the ball cups / studs?
What alternatives do I have to replace the serpent ones but keep the kit cups?

T-works Titanium ball studs you can get them on ebay

any tried if aswesomatix diff fits project 4x car?