Quick question, I have a V3.1 120A. I haven't used it in a while so my recollection of it's functions are vague. When I changed the setting to blinky (no timing/ turbo) the power button blinks red. The controller seems to works fine but i could of sworn it used to blink green. Is the red blinking correct or is something wrong?

Thanks in advance!

Anyone?

My V3.1 stock spec blinks red.

Thanks, i appreciate the input. I would imagine the 120A v3.1 would be the same. Maybe someone else will chime in and confirm.

1S or 2S?

My V3.1 120A 1S esc blinks red @ neutral and rapid green on throttle with zero timing.

Thanks! I have the 2S 120A V3.1, so i would assume this version should be no different and blink red as well in neutral.

Blinking RED @ neutral is normal for blinky mode and if I remember correctly, it blinks green if there is a sensor failure.
Then again there is always the manual...

In non-turbo and non-boost mode my V3.0 is solid red when throttle is at neutral and blinks red when I give it throttle. Is this normal?

Thanks! I checked the manual but i could not locate this info in there.

Do you mean it blinks when you give it slight throttle or full throttle?
If it's slight throttle, your neutral point needs to be calibrated or you may have adjusted your Throttle trim after calibration.
Is your ESC set to "Blinky" mode or is the Boost and Turbo adjusted to "0" zero?

It blinks red at neutral.

Perfect, exactly what you want it to do. Since its 1 cell, red light will blink at .28 seconds/flash. Flashing green is sensor failure
idbdoug

I know this is HW software section but I couldn't fine a HW motor thread.
Here we go: Has anybody tried the Xerun 17.5 V10 motor in stock TC or stock 1/12?
Thanks
idbdoug

Thanks everyone; all set and ready to go!

I have extensively tested 4 pole motors in the last few weeks. Over 320 measurements, and still going on. I will present the results next month here on RC Tech.

I really liked how Xerun 150A performed during 4S and 6S LiPo tests. How nicely one can tume the timing to suit each motor and load.

But I really miss the turbo function for on-road use of our GTe class and in also for C electric class.

Can Xerun 150A be custom updated with Turbo/boost timing? I can be specific... turbo timing range the same AMTS timing is from 0° to 26.25°. Setup for turbo slope, disengage and you can program start RPM. So a mix between turbo/boost on Xerun V3.1 120A.

I would really like this function, since I reall measured each motor at different timings and understand now quite good what is happening. And on some Y wound motors works like "charm" :-) (proved later on on Tekin RX8 ESC). Also Delta would motors on 6S at >2000W and almost 50000 rpm do show similar behaviour :-)

Please, please, please! You can email me at mihah44(at)gmail.com ! Thanks!